Laserfiche WebLink
10) Ia J 2Ga) <br />Appendix A <br />71 SO Overfill Valve Upper Tube Calculation Worksheet <br />Important This is meant to be supplemental worksheet and not a substitute to following the installation <br />manual instructions. All length measurements are in inches. Please contact the Authority Having Jurisdic- <br />tion (AHJ) and review local, state, and national codes to determine the regulatory requirements governing <br />shut-off capacity in your region, as well as take into account other considerations such as extreme tank tilt. <br />Desired tank capacity for shut-off. <br />Dipstick Number on Tank Chart that corresponds to 100% volume (Y) = <br />Dipstick Number on Tank Chart that corresponds to SO% (X) _ <br />Upper Tube Reference Number Z=Y-X <br />Upper Tube Depth Inside Tank C = Z-2" <br />Distance from top sealing surface for 71 SO Lip' to inside the <br />top of Storage Tank2 <br />For Non -Testable 71 SO models only. <br />SO%==3� <br />u (Y) <br />--- (X) <br />L <br />t (C) <br />A- -34 I f� . <br />In all cases for non -testable 71 SO models, the top of the valve body must protrude at least 6 1/z" into the tank to <br />provide a minimal clearance for proper operation.3 Additionally the total Upper Tube Length must beat least 16" <br />of length to include the protective bend in the tube. <br />Is C less than 6 1/2" <br />NO, Upper Tube Length (D)= C + A <br />If YES, Upper Tube Length (D)= 6'/2 "+ A <br />Yes / <br />Upper Tube Length = Li H Ija <br />For Testable 71 SO models only <br />In all cases for Testable 71 SO models, the top of the valve body must protrude at least 6'h" into the tank to provide <br />a minimal clearance for proper operation.3 Additionally the total Upper Tube Length must beat least 141/2" of <br />length to include the protective bend in the tube. <br />Is C less than 5" Yes / No <br />Pc <br />If NO, Upper Tube Length (D)= C + A - 1 'h " <br />If YES, Upper Tube Length (D) = 61/2" + A - 1 1/2 " <br />Upper Tube length = <br />Sealing surface may be the top of the Face Seal Adaptor, the built in sealing ledge inside some spill containers, or on non -vapor <br />tight applications the top of the pipe nipple <br />2 Some Underground Storage tanks utilize Oman woy system at the top. Make sure to use the top of the storage tank for measure- <br />mentand nor to top ofthe manway. Consult your underground tank manufacturer for height of the manway <br />{ This measurement is taken from the seam where the upper tube is attached to the valve body to the inside of the tank top. <br />20 <br />