Laserfiche WebLink
Worksheet for OPW 61 SO ana 71 SO V�h <br /> Appendix B <br /> S li 3' 71 SO Overfill Valve in Tank Shut off Level Worksheet <br /> Important: This is meant to be supplemental worksheet and not a substitute to following the installation <br /> manual instructions. All length measurements are in inches. Please contact the Authority Having Jurisdic- <br /> tion(AHJ)and review local,state,and national codes to determine the regulatory requirements governing <br /> shut-off capacity in your region,as well as take into account other considerations such as extreme tank tilt. <br /> Take the following measurements with the valve in- <br /> stalled in the tank: <br /> Distance from the 71 SO inlet tube flange to the cast <br /> lug in the 71 SO body(see figures),upper tube length. <br /> Note: the Upper Tube Length must be at least 16"to in- <br /> clude the protective bend in the tube. <br /> (D)= yS 6 L �. <br /> Distance from the 71 SO inlet tube flange to the top and <br /> bottom of lower tube,valve length. (D) <br /> (W)= I'l WUpper <br /> (U)= I*+h I y r Tube <br /> Distance from the 71 SO inlet tube flange to the bottom <br /> of the tank. Note:If a tank bottom protector is present it <br /> may be necessary to add this thickness to dimension <br /> (VV)Valve <br /> (OPW 6111 &61TP models add 0.6") Length, <br /> (B)= N;! /`fJ'ft /so /t bottom of <br /> cut <br /> From the tank calibration chart provided by tank manu- <br /> facturer find the dipstick number(Y)which corresponds (B) <br /> to the 100%volume. To Tank <br /> (Y)=1/ti- 11'1 - )II <br /> M <br /> 1. To determine shut-off percentage: Tank <br /> Subtract upper tube length(D)from distance to tank (U)Valve Chart <br /> bottom(B) Length, 100% <br /> (X)_(B)-(D)-2"_ o �7 ���� top of cut Volume <br /> Dipstick <br /> Using the tank calibration chart provided by the tank <br /> manufacturer determine the tank capacity at the cal- <br /> culated(X)dimension and the 100%volume(Y)tank <br /> capacity. -- <br /> (X)tank capacity in gallons <br /> (Y)tank capacity in gallons=1607Y- 50-0' 5037 <br /> SO%=(X)capacity/(Y)capacity x100=i1 y " ELL k0 Note: The overfill valve must be installed per AHJ require- <br /> ments and all applicable local,state,and national codes. If <br /> the overfill valve is set above the allowable shut-off percent- <br /> age the overfill valve must be removed and replaced. For <br /> reference 40 CFR part 280 Subpart B Section 280.20 overfill <br /> valves should be set to a maximum of 95%. <br /> 21 <br />