Laserfiche WebLink
Installing Dispensing Hanging Hardware <br /> Dispensing Hanging Hardware is defined as the connecting point on a dispenser where the Healy System Hose Assembly <br /> or the Healy System Hose Adapter connects to the original dispenser product outlet. <br /> Installing Dispensing Equipment <br /> 1. Completing the connection of Healy Systems dispensing equipment requires the installation of Healy Systems Phase <br /> II dispenser adapters, hoses and nozzles (Hanging Hardware). So, if applicable, remove existing non-Healy hanging <br /> hardware (from the dispenser product outlet adapter to, and including, the nozzles). <br /> 2. Vapor ready dispensers will require a Healy Systems adapter to make the hose threads compatible with other Healy <br /> Systems equipment. Install the adapter according to the instructions that come with it. Various adapters are available, <br /> depending on how the dispenser is configured: M34 metric (Healy designation F3 or S3)or balance ready (Healy <br /> designation S4). <br /> 3. Healy Vapor Recovery Hoses are available in various lengths to satisfy local ordinances and still provide "far side" <br /> fueling capability. Install Healy Vapor Recovery Hoses according to the instructions contained with the product in the <br /> shipping box. <br /> 4. Breakaways are required; install either a model 8701VV Breakaway or a model 807 Swivel Breakaway. Install the <br /> breakaway using the instructions supplied with the unit. <br /> 5. The Healy Systems nozzle Model 900 (EVR) series is the only nozzle necessary to complete the upgrade. Check to <br /> be sure that the nozzle hanger is mounted in the highest position. Check for proper fit in the nozzle holster and that the <br /> nozzle can be locked in the off position.Also be sure that when the nozzle is locked, the dispenser cannot be activated <br /> from the locked position. <br /> Hose Adapters' <br /> • Used for"Non-Vapor Ready" Commercial Dispensers Only (Universal) <br /> • Dispensers containing existing "VacAssist" or"Balance" Stage II piping DO NOT use these adapters. <br /> CX6-A <br /> Non-Vapor Ready, Standard Low Hose Dispensers <br /> CX6—A <br /> HOSE ADAPTER <br /> HON-VAPOR (FIXED ELBOW) <br /> STANDARD UNITS <br /> The Vapor Kits listed below are for use with CX6-A hose adapters <br /> MMMDe 'on <br /> scri <br /> Pt' <br /> o Vapor Kit Z008 Standard low hose/S <br /> Single hose dispenser <br /> Vapor Kit Z009 Standard low hose/ Dual hose dispenser <br /> wx <br /> S L.1 <br /> ' A complete list of dispenser conversion adaptors manufactured by Franklin Fueling Systems is listed in <br /> Exhibit 1. The use of dispenser conversion adaptors not listed in Exhibit 1 may be used to facilitate installation <br /> provided that all applicable performance standards are met. <br /> 8-15 <br /> CARB Approved IBM 8-Healy Universal Manual-Executive Orders VR-281 and VR-282 <br />