COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

2. LIQUID CONDENSATE TRAP PHASE II EVR COMPONENTS Exhibit 1 of VR 201 and VR 202 lists components required for a Phase II EVR System with a Liquid Condensate Trap. Existing Liquid Condensate Traps may already have some of these components installed. Some of these required components are (reference all Figures): Riser Adaptor - This riser adaptor is to be installed on all risers that are connect- INCON Model TSP-K2A ed to the Liquid Condensate Trap, except for the Liquid Conden- sate Trap suction tube riser. In-Line Filter - The purpose of the in-line filter is to trap debris and rust particles Swagelok B-4F2-140 or that are traveling inside the suction line to prevent them from SS-4F2-140 (or equivalent) blocking the syphon jet valve at the turbine pump. This in-line filter is installed at the syphon inlet of the turbine pump. Stainless Steel Wired Braided Connects the suction tube to the turbine pump. Hose or 1/4" Copper Tubing (rated for use with gasoline)_ Aluminum or Stainless Steel This screen can be purchased from almost any hardware Insect Screen with Stainless store. The specifications are: 18 X 14 mesh for aluminum Steel Hose Clamp insect screen and 18 X 18 mesh for stainless steel insect screen. A small section of this screen material is installed over the end of the suction tube inside the Liquid Conden- sate Trap and secured with a SS hose clamp. Liquid Sensor Connection Many sites already have existing liquid sensors installed to the UST Monitoring System inside the Liquid Condensate Trap. If a liquid sensor does not exist inside the Liquid Condensate Trap then one must be installed. Any Liquid sensor installed inside the Liquid Condensate Trap must meet the following minimal requirements: • Provides a visual and audible alarm in case of failure of the evacuation system; • The audible and visual alarm monitoring system must be installed at a location that is most likely to be heard by the station attendant during normal station operation; • Set the liquid sensor to the height shown in Figure 5. Various Pipe Fittings For adapting the suction line, as required, and to add a in '/4" and 2" Sizes fuel entry point with a plug or cap to the Liquid Condensate Trap riser. Optional Equipment: Secondary Syphon Kit -- For use when two syphon primers are required for one Sub- Franklin Fueling Systems mersible Turbine Pump (STP). One to syphon the Liquid Part Number 402507930 Condensate Trap and one for siphoning two or more tanks of like product grade. 9-2 CARR Approved IN 9-Liquid Condensate Trap-EXECUtiVe Orders VR-201 and VR-202