Laserfiche WebLink
Appendix B <br /> Swagelok F-Series In-Line Filter Service Instructions <br /> Spring Female Body <br /> .�t1 x <br /> Male Body Gasket <br /> Element <br /> Disassembly <br /> 1. Loosen male and female bodies and disassemble. <br /> 2. If replacing the filter element, remove and discard used element. <br /> Reassembly <br /> 3. Before reassembling the filter, be certain that all components are clean. <br /> 4. Align the new filter element parallel to the filter bore of the female body. Position the open <br /> end of the element towards the body and press in place. <br /> 5. Lubricate the gasket with a thin film of system-compatible lubricant. Place gasket on male <br /> body seal surface. <br /> 6. Place the spring in to the male body. <br /> 7. Thread the male and female bodies together, and tighten finger-tight. <br /> 8. Tighten the bodies to the proper torque as shown in the table below. <br /> 9. Test the filter for proper operation and leak-tight sealing. <br /> Torque, in.-Ib. (N-O) <br /> Standard Assembly Unplated Gasket <br /> Size and Series Stainless Steel Brass Stainless Steel <br /> 1 F, 2F, 3F-OM 135 (15) 125 (14) — <br /> 4F, 6F-OM 350 (40) 325 (36) 500 (56) <br /> 6F, 8F, 10F-OM, 500 (56) 450 (50) 800 (90) <br /> 12F-OM <br /> s-21 <br /> GARB Approved IN 9-Liquid Condensate Trap-Executive Orders VR-201 and VR-202 <br />