Laserfiche WebLink
Setup Alarm Setup <br /> Figure 13 illustrates the setup steps required to assign ISD Shut Down Alarms to a tank using either a Four Relay <br /> Output Module or an 1/0 Combination Module. <br /> EMode ]Backup©Change EE Eller R p mil <br /> �devredmessege t p KeYPress <br /> F�F—ft.Estee IISennkr©Pnht appearsin display sequence <br /> I isd-ha.ly.lm a.tup..ps <br /> I I <br /> Prints out a copy of the <br /> RELAY CONFIG-MODULE X © Output Relay Setup entries. <br /> S SLOT#—X X X X See example in next figure. <br /> This display shows 4 Relays and indicates <br /> a 4-Relay Output module. <br /> RELAY CONFIG-MODULE X <br /> SLOT#—XX <br /> This display shows 2 Relays and indicates <br /> a I/O Combination module-2 relays only. <br /> At either display above,move the cursor to <br /> an unassigned relay(X,)press Change twice <br /> then press Enter to assign the first relay. <br /> S ENTER RELAY DESIGNATION Press Change and enter a name for the <br /> R1: relay.Press Enter to accept your entry. <br /> R1:SELECT RELAY TYPE Press Change until the above <br /> S STANDARD Relay Type displays then press <br /> Enter. <br /> S R1:SELECT TANK <br /> T1:(Grade) <br /> S R1:SELECT ORIENTATION If necessary,press Change until <br /> NORMALLY CLOSED the recommended orientation <br /> (closed)displays then press Enter. <br /> RX:(Name) ISD SITE ALARMS:YES n <br /> ISD SITE ALARMS:NO C E PRESS<STEP>TO CONTINUE a = See ISO SITE ALARMS <br /> $ <br /> See required alarms below:YES <br /> ISO GROSSPRESFAIL� /Press <br /> achoftSbuttons tshowchange the status <br /> JII'/ of each of the alarms shown to YES.These <br /> ISO DEGRD PRES FAIL alarms are REQUIRED by CARS to be set to <br /> ISO VAPOR LEAK FAIL YES. <br /> IMPORTANT!Failure to set these alarms to <br /> ISO SETUP FAIL` YES will result in an ISD Setup Self-Test <br /> ISD SENSOR OUT FAIL* Alarm. <br /> *Thesealarms are recommended by CARS <br /> to be set to YES. <br /> R1:(Name) #1 C ISD HOSE ALARMS:YES R1:ISO HOSE ALARMS <br /> ISO HOSE ALARMS:NO PRESS<STEP>TO CONTINUE See required alarms below:YES <br /> QA <br /> Do not assign hose alarms when IRS LOLL FL <br /> Dispenser Relay Shutdown is used for Press C/E/S buttons to change the status of each <br /> hose alarms. DGRO COL FL ofthe alarms shown to YES.These alarms are <br /> REQUIRED by CARB to be assigned to submersible <br /> If necessary,you need to repeat the above ISD turbine pumps or to dispenser relays. <br /> a- ENTER RELAY DESIGNATION SITE/HOSE Shutdown Alarm setups for each of the IMPORTANT!Failure to assign hose alarms for <br /> remaining tanks. <br /> RX: shut down of submersible turbine pumps or <br /> Press Change and enter a name for the second relay. dispensers will result in an ISD Setup Self-Test <br /> Press Enter to accept your entry. Alarm. <br /> Figure 13. Assigning ISD Shut Down Alarms in Output Relay Setup <br /> 10-20 <br /> GARB Approved IBM 10 -Veeder Root ISD Install,Setup,9 Operation Manual-Executive Order VR-202 <br />