Laserfiche WebLink
ISD Operability Test Pr• • <br /> The following procedures shall be used at field sites to determine the operability of the Veeder-Root ISD system to <br /> satisfy the requirements documented in VAPOR RECOVERY CERTIFICATION PROCEDURE, CP-201, <br /> CERTIFICATION PROCEDURE FOR VAPOR RECOVERY SYSTEMS AT GASOLINE DISPENSING <br /> FACILITIES.Testing the ISD equipment in accordance with this procedure will verify the equipment's operability <br /> for Vapor Containment Monitoring and Vapor Collection Monitoring. <br /> Veeder-Root's TLS console ISD System Self-Test Monitoring algorithms are designed to verify proper selection, <br /> setup and operation of the TLS console modules and sensors and will not complete and report passing test results <br /> in the event of a failure of components used in the system. Completed ISD monitoring tests are evidence that: <br /> • The system was properly powered for data collection <br /> • All necessary ISD sensors were setup and connected <br /> • All necessary ISD sensors were operating within specification <br /> • All internal components including TLS console modules were properly setup and operating within specification <br /> Veeder-Root recommends printing a copy of the ISD ALARM STATUS and ISD DAILY report (REF. Section 5, <br /> Operation of the ISD Install, Setup &Operation Manual) periodically to determine that compliance tests are being <br /> completed in accordance with local and state regulations. <br /> A step-by-step worksheet for recording data from the following operability tests is provided in Appendix B. <br /> Vapor Pressure Sensor Verification Test <br /> See EO VR 202 Exhibit 9 for the Pressure Sensor Verification Test. <br /> Vapor Flow Meter Operability Test <br /> See EO VR 202 Exhibit 9 for the ISD Vapor Flow Meter Operability Test Procedure. <br /> 10-24 <br /> CARO Approved IOM 10 -Veeder Root ISD Install,Setup,5 Operation Manual-Executive Order VR-202 <br />