COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

Operation Viewing ISD Reports via RS-232 Connection 5. Next you should see the `Port Settings' window. IMPORTANT!The settings of the laptop's com port must match those of the console's com port to A!O which you are connected. a. Go to the console front panel press the MODE key until you see: SETUP MODE PRESS<FUNCTION>TO CONT b. Press the FUNCTION key until you see the message: COMMUNICATIONS SETUP PRESS<STEP>TO CONTINUE c. Press the STEP key until you see the message: PORT SETTINGS PRESS<ENTER> d.Press the PRINT key to printout the port settings for all communication modules installed in the console.Figure 28 shows an example port settings printout with the RS-232 module installed. Using the console port settings in the example below,your HyperTerminal `Port Settings' window entries would be Bits per second-2400,Data bits-7,Parity-Odd, Stop Bits- 1.For the `Flow Control' entry select None.Click OK. This number is the assigned by the console and indicates the slot in which the RS-232 module is installed.It could be 1,2, or 3. PORT SETTINGS However,for the RS-232 port of a Multiport module,which is installed in slot 4,this number would be 6. COMM BOARD: 1 (RS-232) BAUD RATE: 2400 PARITY: ODD STOP BIT: 1 STOP DATA LENGTH: 1 DATA RS-232 SECURITY CODE: DISABLED If no RS-232 Security Code has been entered,you will see disabled. If a code has been entered, e.g.,000016,that 6-digit number would isd\portset.eps appear here. If a code appears,you will need to enter this code with each command you send to the console. Figure 28. Console Comm Port Settings Printout Example In the example port settings printout above, the RS-232 Security Code is disabled. If the code was enabled you would see a 6-digit number which you will need to enter to access the console (refer to the `Sending Console Commands' paragraph below for more information). IB-37 CARB Approved IBM 10 -Veeder Root ISD Install,Setup,S Operation Manual-Executive Order VR-262