Laserfiche WebLink
Diagnostic Menus <br /> CALIBRATE SMARTSENSOR El HM Mode Backup©Change QEnter <br /> PRESS<ENTER> 4Repressuntil � Key press <br /> desired message 2 sequence <br /> This menu only appears Fs-] F�Function S]Step E Sensor Tank ❑P Print appears in display <br /> if this Smartsensor type <br /> is a pressure sensor. ISD-EVR/fig3.eps <br /> CALIBRATE SMARTSENSOR <br /> PRESS<STEP>TO CONTINUE P Prints out sensor calibration history see example <br /> LR <br /> ESSURE SENSOR <br /> at right.F-slION HISTORY <br /> OR PRESSURE-DD-YY HH:MMs t: VAPOR PRESSUREThis is the current uncalibrated value read by the pressure : XXXXXXXXPRESSURE: -XX.XXX sensor. XXXX.XXXXXXX.XXX❑S TUS: PASS <br /> ENTER ZERO REFERENCE Enter reference pressure value from calibrated test device at <br /> PRESSURE: +XX.XXX pressure sensor via TLS Console front panel,e.g.,ambient <br /> pressure(0.0).This is the first point of the calibration slope. <br /> S <br /> READ ZERO VALUE Wait until the read zero pressure value stabilizes and no longer <br /> PRESSURE: -XX.XXX changes,then press STEP. <br /> ENTER SPAN REFERENCE Enter span reference pressure value from calibrated test device at <br /> PRESSURE: -XX.XXX pressure sensor via TLS Console front panel,e.g.,2 psi.This is <br /> ❑S the second point of the calibration slope. <br /> READ SPAN VALUE Wait until the read span pressure value stabilizes and no longer <br /> .X <br /> PRESSURE: -XXXX changes,then press STEP. <br /> Fc—ALB STATUS:PASS This message will only appear after all 4 values have been <br /> PRESS<STEP>TO CONTINUE successfully obtained and the calibrated slope and offset are <br /> within acceptable limits. <br /> ID-45 <br /> GARB Approved IDM 10 -Veeden Root ISD Install,Setup,D Operation Manual-Executive Order VR-202 <br />