Laserfiche WebLink
ISD Flow Meter Installation Guide Safety Precautions <br /> Safety Precautions <br /> The following safety symbols may be used throughout this manual to alert you to important safety hazards and <br /> precautions. <br /> EXPLOSIVE FLAMMABLE <br /> Fuels and their vapors are extremely Fuels and their vapors are extremely <br /> explosive if ignited. y, � flammable. <br /> ELECTRICITY TURN POWER OFF <br /> High voltage exists in,and is supplied Live power to a device creates a <br /> • to,the device.A potential shock haz- ; potential shock hazard.Turn Off <br /> and exists. �j power to the device and associated <br /> accessories when servicing the unit. <br /> READ ALL RELATED MANUALS USE SAFETY BARRICADES <br /> Knowledge of all related procedures Unauthorized people or vehicles in <br /> before you begin work is important. the work area are dangerous.Always <br /> Read and understand all manuals use safety cones or barricades, <br /> thoroughly. If you do not understand safety tape,and your vehicle to block <br /> a procedure,ask someone who doesthe work area. <br /> Related Manuals <br /> 576013-879 TLS-3XX Series Consoles Site Prep Manual <br /> 577013-879 TLS-450 Series Consoles Site Prep Manual <br /> 577013-800 In-Station Diagnostics Install, Setup&Operation Manual <br /> 577013-964 TLS RF Wireless 2 System (W2) Installation and Maintenance Guide <br /> Before You Begin <br /> • A level 1 or higher certified Veeder-Root Technician must be available (on site) to assist in this type of <br /> installation. <br /> • Comply with all recommended safety practices identified by OSHA (Occupational Safety and Health <br /> Administration) and your employer. <br /> • Follow all installation requirements as per NFPA (National Fire Protection Association) 30, 30A, and 70. <br /> • Review and comply with all the safety warnings in the installation manuals and any other national, State or Local <br /> requirements. <br /> • When directly wiring to a TLS console, a 2-conductor, 18 AWG shielded cable must be installed in intrinsically <br /> safe conduit from each dispenser to the intrinsically safe wiring compartment of the TLS console. <br /> • Debris from plumbing modifications should be flushed through the piping system prior to installing the ISD <br /> Vapor Flow Meter. <br /> • Use only UL classified Gas/TFE yellow teflon tape on all fittings. Do not use pipe dope to seal pipe threads or <br /> fittings in and out of the ISD Vapor Flow Meter. <br /> ID-4 <br /> GARB Approved IBM 10 -Veeder Root ISD Vapor Flow Meter-Executive Drder VR-202 <br />