COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

Introduction General Precautions WARNING READ ALL RELATED MANUALS AHeed the adjacent instructions to avoid dam- Knowledge of all related procedures before you age to equipment,property,environment or begin work is important.Read and understand all personal injury. manuals thoroughly.If you do not understand a I (�� procedure,ask someone who does. SAFETY BARRICADES Unauthorized people or vehicles in the work rjJ area are dangerous.Always use safety cones or barricades,safety tape,and your vehicle to block the work area. General Precautions Retain and follow all product safety and operating instructions. Observe all warnings on the product and in the operating instructions.To reduce the risk of bodily injury, electric shock,fire, or damage to the equipment, observe the following precautions. QFAILURE TO COMPLY WITH THE FOLLOWING WARNINGS AND SAFETY PRECAUTIONS COULD CAUSE DAMAGE TO PROPERTY, ENVIRONMENT, RESULTING IN SERIOUS INJURY OR DEATH. GENERAL PRECAUTIONS Heed service markings: Opening or removing the console cover may expose you to electric shock. Servicing of Veeder-Root equipment must be done by Veeder-Root authorized service contractors. Use product with approved equipment: This product should be used only with Veeder-Root components identified as suitable for use with the TLS RF Wireless System. Use the correct external power sources:This product should be operated only from the type of power sources indicated on the electrical ratings labels affixed to the components. If you are not sure of the type of power source required, consult your Veeder-Root authorized service contractor. When not in use, a longer battery life can be achieved by keeping the battery pack in a cool, dry location where the temperature never exceeds 30°C or 86'F and does not go below 10'C or 50' F. SPECIAL TOOLS REQUIRED • #15 Torx screwdriver • Small blade screwdriver (maximum blade width 3/32") • Wire strippers National Electrical Code Compliance The following information is for general reference and is not intended to replace recommended National Electric Code (NEC) procedures. It is important for the installer to understand that electrical equipment and wiring located in Class I, Division 1 and 2 installations shall comply with the latest appropriate articles found in the National Electric Code (N FPA 70) and the Code for Motor Fuel Dispensing Facilities and Repair Garages (N FPA 30A), or other local code such as the CEC, Canadian Electrical Code. TLS RF-TO-TLS CONSOLE WIRING Wire Type To ensure the best operating systems available, Veeder-Root REQUIRES the use of shielded cable. to-e GARB Approved IOM 10-Veeder Root TLS RF Wireless Systems(W2)-Executive Order VR-202