COMPLIANCE INFO_2021 - Laserfiche WebLink

Home Browse Search

Pre-installation • • Functional The steps below describe the process of verifying the Wireless System component functionality; listed steps are only for one TLS RE If there are more than 8 Sensors installed at the site, refer to Appendix B on how to setup the DIP Switches for auxiliary TLS RF(s). 1. Remove all the hardware from their boxes; lay the TLS RF, Receiver, Repeater, and all the Transmitters on a table. 2. Set Site ID for the Receiver, Repeater, and all the Transmitters (refer toAppendix B on how to set up the Site ID).Typically the Site ID is set to 0 (default). If there is a nearby wireless site,the Site IDs must be different. 3. Set all Transmitter's Device Numbers and connect the battery cables to all the Transmitters. Label each Transmitter with its site ID. a. Using a#15 torx driver, remove the cover of the Transmitter. b. Remove the nut from the battery cable cord grip (right side cord grip) and slide it over the non-connector end of the battery cable. c. Make sure the battery/dc power cable is not connected to the battery pack or do power source at this time. Push the battery cable through the battery cable cord grip bushing and into the Transmitter. d. Strip back the cable jacket and wires as shown in Figure 4. e. Connect the battery pack/dc power cable to the BATTERY terminal block (white to +IN and black to -IN) as shown in Figure 5. 1 f. Hand tighten both cable entry cord grip nuts to prevent water entry! g. Replace the cover of the Transmitter, but do not tighten down cover screws at this time. 1/4'' 1-1/4" > X3/32"(2.4mm) rl 41 ----- 964-40.eps Figure 4. Connecting Wiring To Device Terminal Blocks LEGEND FOR • BOXES IN Figure 4 1. Strip back cable and wire jackets the amount shown. 3. Both wires must be tight in terminals! 2. Use a screwdriver with the proper blade width. 10-11 CARO Approved IOM 10-Veeder Root TLS RF Wireless Systems(W2)-Executive Order VR-202