Laserfiche WebLink
TLS RF Installation <br /> Selecting A Location <br /> A WARNING <br /> ,c Explosive vapors or flammable liquids could be present near locations where <br /> fuels are stored or being dispensed.The TLS RF is not explosion proof. <br /> An explosion or fire resulting in serious injury or death, property loss and <br /> equipment damage could occur if the console is installed in a volatile, <br /> combustible or explosive atmosphere(Class I, Division 1 or 2). <br /> Do not install this unit in a volatile,combustible,or explosive atmosphere. <br /> The TLS RF must be mounted indoors, protected from severe vibration, extremes in temperature and humidity, and <br /> other conditions that could harm computerized electronic equipment. <br /> Ensure that the TLS RF is located where neither it nor its associated cabling will be damaged by doors, furniture, <br /> etc. Consider the ease of routing wiring, and ducting to the TLS console. Check that the mounting surface is <br /> strong enough to support the unit's weight of about 4 pounds. <br /> Mounting the TLS RF <br /> Install the unit's fastening devices to the mounting surface using the hole pattern (6.7" x 5.7") shown in Figure 2. <br /> Mounting screws up to 3/16" diameter may be used. <br /> Install metal conduit (1/2-inch I.P.S.) between the upper power side knockout on the unit and the power panel. <br /> Figure 2 shows the two designated knockouts (one each on top and bottom) through which power wiring can <br /> safely enter the unit. <br /> Also install metal conduit (1/2-inch I.P.S.) between the lower intrinsically-safe wiring knockout on the TLS RF and <br /> an intrinsically-safe wiring knockout on the TLS console for device data wiring. <br /> Wiring the TLS RF <br /> A WARNING <br /> 00) <br /> The unit contains voltages which can be lethal. <br /> Connecting power wires to a live circuit can cause electrical shock that may result <br /> in serious injury or death. <br /> Turn power off at the circuit breaker before connecting wiring to the TLS RF. <br /> Attach conduit from the power panel to the unit's power wiring knockouts only(1 <br /> on top and 1 on bottom, ref. Figure 2) <br /> To connect power wiring see Figure 6. To connect Receiver wiring see Figure 7.To daisy chain two TLS RFs, see <br /> Figure 9 and Figure 10.To connect TLS RF data output wiring to the TLS console see Figure 6. <br /> 10-14 <br /> CARE Approved IOM 10-Veeder Root TLS RF Wireless Systems(W2)-ExeCAVE Order VR-202 <br />