|
Page No.6 of 9
<br /> systems must contain a functional reduced-pressure zone(RPZ),back flow preventer or the functional equivalent in the water
<br /> supply line upstream from the point of pesticide introduction.As an option to the RPZ,the water from the public water system
<br /> should be discharged into a reservoir tank prior to pesticide introduction.There shall be a complete physical break(air gap)
<br /> between the outlet end of the fill pipe and the top or overflow rim of the reservoir tank of at least twice the inside diameter of the fill
<br /> pipe.-The system must contain a functional check valve,vacuum relief valve,and low pressure drain apropriately located on the
<br /> irrigation pipeline to prevent water source contamination from back flow.-The pesticide injection pipeline must contain a
<br /> functional,automatic,quick-closing check valve to prevent the flow of fluid back toward the injection pump.-The pesticide injection
<br /> pipeline must contain a functional,normally closed solenoid-operated valve located on the intake side of the injection pump and
<br /> connected to the system interlock to prevent fluid from being withdrawn from the supply tank when the irrigation system is either
<br /> automatically or manually shut down.-The system must contain functional interlocking controls to automatically shut off the
<br /> pesticide injection pump when the water pump motor stops,or in cases where there is no water pump,when the water pressure
<br /> decreases to the point where pesticide distribution is adversely affected.-The irrigation line or water pump must include a
<br /> functional pressure switch that will stop the water pump motor when the water pressure decreases to the point where pesticide
<br /> distribution is adversely affected.-Systems not connected to a public water supply must contain a functional check valve,vacuum
<br /> relief valve,and low-pressure drain appropriately located in the irrigation pipeline to prevent water source contamination from back
<br /> flow.-Systems must use a positive displacement,metering injection pump(e.g.,diaphragm pump),effectively designed and
<br /> constructed of materials that are compatible with pesticides and capable of being fitted with a system interlock.-Do not apply when
<br /> wind speed favors drift beyond the area intended for treatment.-If you have questions about calibration,you should contact State
<br /> Extension Service specialists,equipment manufacturers or other experts.Aerial Application Mount the spray boom on the aircraft so
<br /> as to minimize drift caused by wing tip or rotor vortices.Use the minimum practical boom length and do not exceed 75%of the
<br /> wing span or 80%of the rotor diameter.Flight speed and nozzle orientation must be considered in determining droplet size.Spray
<br /> must be released at the lowest height consistent with pest control and flight safety.Do not release spray at a height greater than 10
<br /> feet above the crop canopy unless a greater height is required for aircraft safety.When applications are made with a crosswind,the
<br /> swath will be displaced downwind.The applicator must compensate for this displacement at the downwind edge of the application
<br /> area by adjusting the path of the aircraft upwind.Rainfastness As soon as dry,Intrepid 2F will resist wash-off better than most
<br /> insecticides.However,efficacy or residual will be reduced with exposure to rainfall or overhead irrigation.Spray Adjuvants The
<br /> addition of agricultural adjuvants to sprays of Intrepid 2F may improve initial spray deposits,redistribution and weatherability.Select
<br /> adjuvants that are recommended and registered for your specific use pattern and follow their use dire ctions.When an
<br /> adjuvant is to be used with this product,Dow AgroSciences recommends the use of a Chemical Producers and Distributors
<br /> Association certified adjuvant.Always add adjuvants last in the mixing process.
<br /> Notice 21 of 35(Quick Ultra with Awaken 7-28-4)WARNING:This product contains Boron(B).Use of this fertilizing material on
<br /> any crops other than those recommended may result in injury to the crops.Use only according to manufacturer's directions.
<br /> WARNING:This product contains Molybdenum(Mo).Application of fertilizing materials containing molybdenum(Mo)may result in
<br /> forage crops containing levels of molybdenum(Mo)which are toxic to ruminant animals.
<br /> Notice 22 of 35(Quick Ultra with Awaken 7-28-4)GENERAL INFORMATION QUICK ULTRA WITH AWAKEN(R)is formulated to
<br /> contain polyphosphates for more efficient utilization of the phosphorous by the plant.Quick Ultra with Awaken is designed for use
<br /> as a foliar spray over the row during early seeding growth stages to encourage strong root system development.It supplies the
<br /> nutrients needed by young plants growing under cool,wet conditions.It can also be used as a"Pop-up"fertilizer when used with
<br /> properly configured planters in covering soil or close to the seed.Quick Ultra with Awaken also contains an enriched package of
<br /> micronutrients in highly available EDTA/HEDTA form.Designed for foliar application,it supplies vital nutrients at or near the time
<br /> they are needed most.
<br /> Notice 23 of 35(Quick Ultra with Awaken 7-28-4)RECOMMENDED RATES:SOIL APPLICATION:Apply 2-4 quarts per acre at
<br /> planting as a"Pop-Up"fertilizer in properly configured planters,in covering soil or close to the seed.
<br /> Notice 24 of 35(Quick Ultra with Awaken 7-2841 Crop Safety:This product has been tested on a number of crop varieties with no
<br /> phytotoxicity observed at labeled rates;however,this product has not been tested on all varieties and cultivars.Due to the large
<br /> number of plant species and their associated varieties or cultivars,and due to variable growing conditions,it is impossible to test
<br /> every plant for tolerance to this product.It is the responsibility of the user to determine if this product can be used safely prior to
<br /> commercial use.In a small test area,test the specified rates on plants for phytotoxicity prior to general use.Before using any tank
<br /> mix,test the combination on a small portion of the crop to be treated to ensure that a phytotoxic response will not occur as a result
<br /> of application.Treat a small group of target crop including plant cultivars and evaluate for 3-7 days prior to making an application
<br /> to your entire crop.If there is contact made with spray solution containing pesticides and/or spray adjuvants,follow the FIRST AID
<br /> STATEMENT on the pesticide label.
<br /> Notice 25 of 35(Quick Ultra with Awaken 7-28-4)QUICK ULTRA WITH AWAKEN is corrosive to aluminum,mild steel and brass.
<br /> Store and/or ship in polypropylene,fiberglass or stainless steel containers.Use only stainless steel,or P.V.C.fittings.
<br /> Notice 26 of 35(Quick Ultra with Awaken 7-28-4) 1st application at first bloom.Can repeat as necessary every 14-21 days until
<br /> harvest.
<br /> Notice 27 of 35(Narrow Ranae 415 Sorav Oil)PERSONAL PROTECTIVE EQUIPMENT(PPE)Some materials that are
<br /> chemical-resistant to this product are barrier laminate,nitrile rubber,neoprene rubber,and viton.If you want more options,follow
<br /> the instructions for category E on an EPA chemical-resistance category selection chart.Mixers,loaders,applicators,flaggers and
<br /> other handlers must wear:-Long-sleeved shirt and long pants,-Shoes plus socks,and-Chemical-resistant gloves.Follow
<br /> manufacturer's instructions for cleaning/maintaining PPE.If no such instructions for washables exist,use detergent and hot water.
<br /> Keep and wash PPE separately from other laundry.Discard clothing and other absorbent materials that have been drenched or
<br /> heavily contaminated with the product's concentrate.Do not reuse them.ENGINEERING CONTROLS Pilots must use an enclosed
<br /> cockpit that meets the requirements listed in the WPS for agricultural pesticides[40CFR 170.240(d)(6)].USER SAFETY
<br /> RECOMMENDATIONS Users should:-Wash hands before eating,drinking,chewing gum,using tobacco or using the toilet.-
<br /> Remove clothing/PPE immediately if pesticide gets inside.Then wash thoroughly and put on clean clothing.-Remove PPE
<br /> immediately after handling this product.Wash the outside of gloves before removing.As soon as possible,wash thoroughly and
<br /> change into clean clothing.ENVIRONMENTAL HAZARDS Do not apply directly to water or areas where surface water is present or
<br /> to intertidal areas below the mean high water mark.Do not contaminate water when disposing of equipment washwater or rinsate.
<br /> Drift and runoff may be hazardous to aquatic organisms in water adjacent to treated areas.DIRECTIONS FOR USE It is a violation
<br /> of Federal law to use this product in a manner inconsistent with its labeling.Do not apply this product through any type of irrigation
<br /> system.Do not apply this product in a way that will contact workers or other persons,either directly or through drift.Only protected
<br /> handlers may be in the area during application.For any requirements specific to your State or Tribe,consult the agency responsible
<br />
|