COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

Environmental Health Department AMENDED 10/30/2019 Small Quantity Hazardous Waste Generator Inspection Report Date: October 24, 2019 Facility Address: 2475 Naglee Rd, Tracy Facility Name: ULTA BEAUTY #579 (Tracy) SUMMARY OF VIOLATIONS (CLASS I, CLASS II, or MINOR - Notice to Comply) RemarksItem # 102 CCR 66262.11 Failed to determine if a waste is a hazardous waste. OBSERVATION: A closed tub about half filled with a blue solution and labeled "Quatz/Barbercide," was observed next to a sink in the Ulta Salon (see photo IMG 9035). According to Sarah Fellows, a Salon Stylist, the solution is used to disinfect the hair tools used by the Salon employees, and is made according to the directions on the Barbicide container. Barbicide, according to its container label, is a (liquid) germicide, psuedomonacide, fungicide, & virucide (IMG 9037). The directions on the Barbicide container state: "To make a Hospital Disinfectant mix 2 ounces of Barbicide in 32 ounces of water. Barbicide is for use in hospitals, heath care facilities, tanning facilities and in beauty salons, barbershops, and hairstyling establishments...Beauty/Barber Instruments and Tools: Thoroughly clean brushes, combs, clipper blades, shears, razors, and other inanimate hard surfaced non-porous tools and implements prior to complete immersion for 10 minutes (or as required by local authorities) in a solution as prepared above. Rinse to remove Barbicide after immersion and dry before used. Fresh solution must be prepared daily or more often if solution becomes diluted or soiled" (IMG 9039). According to Sarah, a tub of the Barbicide solution is made at the beginning of each day, and then the solution is poured down the Salon sink at the end of each day. Sarah stated that if the solution becomes too dirty during the day, the solution will be disposed of and a new batch of the solution will be made. Beneath the sink was an empty tub labeled "Ship Shape" and a bag of Ship Shape Comb & Brush Cleaner powder (IMG 9042, 9047, 9048). According to Sarah, a solution of Ship Shape is also made at the beginning of each day and poured into the sink at the end of each day, however the Ship Shape solution had not been made at the time of inspection. Sarah stated the Salon's hair tools are cleaned in the tub of Ship Shape solution, then disinfected in the tub of Barbicide solution. The Barbicide was labeled "Corrosive. Cause Irreversible Eye Damage And Skin Burns." and "Pesticide wastes are acutely hazardous" (IMG 9038). Also, according to the Barbicide Concentrate Safety Data Sheet (SDS), Barbicide Concentrate is a category 3 flammable liquid, under Occupational Safety and Health Administration (OSHA) regulations. The Ship-Shape was labeled "Warning: Causes Skin Irritation" and "Causes Serious Eye Irritation" (IMG 9042-3). REGULATION GUIDANCE: Any person who generates a waste shall determine if the waste is a hazardous waste as specified in Title 22 California Code of Regulations (CCR). There are wastes that are listed as hazardous wastes. There are wastes that exhibit one or more of the hazardous waste characteristics: toxic, corrosive, reactive or ignitable. CORRECTIVE ACTION: Immediately stop disposal of the Barbicide and Ship Shape solutions down the drain, make a hazardous waste determination for each waste , and manage it according to Title 22 CCR. Use Safety Data Sheets (SDS), waste sampling and test results or other knowledge to support your hazardous waste determination. Waste testing must be done using methods specified in Title 22 CCR including sections 66261.20-24. Submit a statement and supporting documentation with your hazardous waste determination. Demonstrate current storage and labeling for wastes determined to be hazardous wastes. Provide disposal records for wastes FA0023419 PR0540931 SC001 10/24/2019 EHD 22-01 Rev. 9/20/2019 Small Quantity Hazardous Waste Generator OIRPage 5 of 9 1868 E. Hazelton Avenue | Stockton, California 95205 | T 209 468-3420 | F 209 464-0138 | www.sjcehd.com