Laserfiche WebLink
TABLE 24 <br /> Product Removal Skimmer System-Operational Data <br /> Tidewater Stockton(Parcel 2A) <br /> 666 W Weber Avenue,Stockton,CA <br /> Product Recovery System <br /> MW-43 MW47 MW-48 MW49 MW-50 Total <br /> Compressor Operatimal Data <br /> Date Notes System <br /> Compressor QED Dip Dip Volume Volume Volume Volume Volume Total Volume <br /> System Status(On/Off) Operation Process Compressor Cycle Cumulative UT Product Product Product Product Product <br /> Hourmeler Pressure Stick Stick DTW DTP Recovered DTW DTP Recovered DTW DTP Recovered DTW DTP Recovered DTW DTP Recovered Recovered <br /> Hourmeter, Pressure Pressure Interval Recovery R(cm) Thickness Thickness Thickness Thickness Thickness <br /> Reading Reading (Psi) (Psi) Reagulator (min) Reading Reading (gal) (cm) (ft) (ft) (ft) <br /> Product (tt) (ft) Iff) Product (tt) (tt) (ff) Product (tt) (tt) Mi Product (tt) (ft) (ff) Product Product <br /> (hire) (hrs) (psi) (cm) (gal) (gal) (gal) (gal) (gal) (gal) (gal) <br /> Arrival FDeprture <br /> Notes&Definiticil <br /> him=Hours <br /> DTW=depth to water <br /> min=minute <br /> DTP=depth to product <br /> Its=ponds <br /> Vol. volume <br /> r=percent <br /> sofm=standard cubic feet per minute <br /> psi=ponds per square inch <br /> —=Not collected/measured <br /> vol=volume <br /> gal=gallons <br /> UT=Ultrasonic level transmitter <br /> water=water retained in passive skimmer <br /> dip stick reading in gallons based on conversion chart <br /> passive skimmer=MW-03,MW-47,Mi and MW-49(2"wells) <br /> passive skimmer=QED 2'SOS 301080(30 m canister) <br /> 1=Permit Exemption Limit:51.5(gal/day) <br /> a=baseline readings and bump testing <br /> b=Bump testing for startup <br /> c=System found shutdown due to leak detection alarm,reapplied vacuum to tank and tightened fittings,system started <br /> d=Carbon drum was changed,two carbon drums were added in series <br /> e=Vac event was performed on 10/14/13 to remove all the product in tank and passive skimmers well <br /> f=Depth of passive skimmer was adjusted to 17.5 feel from 19 feat because of water <br /> g=Leak detection alarm <br /> h=Leak detection alarm,silicone grease applied to the interstitial cap per manufacturer's recommendations <br /> i=System turned off on departure due to broken level switch in MW-50 <br /> j=float switch in MW-50 replaced.System turned off on departure due to leak detection alar <br /> k=Manufacturers(Newterra)onsite to troubleshoot leak alarm.Leak alarm connected by cleaning Interstitial cap gasket <br /> I=Naw hour meter installed to track system hours(skimmers operation hours actual) <br /> m=Ultrasonic meter showed error on the display screen <br /> n=System was turned off due to high larval on the product tank and vac event <br /> o=System started after the vac event on March 10,2014 <br /> p=Started pulling water in the product tank,shutdown system to adjust the skimmer ficat range depth and gauge well <br /> q=Skimmer depth adjusted to 1T age,Newterra make,cleaned vacuum switch <br /> r=Changed refills time from 3 to 10 mins <br /> TW P2A Skimmer Tables.bg.xlsx 2 of 2 Stantec <br />