Laserfiche WebLink
Site: CHARTER SHELL <br /> Appendix B Date: 6/18/21 <br /> 71 SO Overfill Valve in Tank Shut off Level Worksheet Tank ID D S L Tester Z N <br /> Important: This is meant to be supplemental worksheet and not a substitute to following the installation <br /> manual instructions. All length measurements are in inches. Please contact the Authority Having Jurisdic- <br /> tion (AHJ)and review local,state,and national codes to determine the regulatory requirements governing <br /> shut-off capacity in your region,as well as take into account other considerations such as extreme tank tilt. <br /> Take the following measurements with the valve in- <br /> stalled in the tank: <br /> Distance from the 71 SO inlet tube flange to the cast <br /> lug in the 71 SO body(see figures),upper tube length. <br /> Note: the Upper Tube Length must be at least 16"to in- <br /> clude the protective bend in the tube. <br /> (D)=74-- (L <br /> Distance from the 71 SO inlet tube flange to the top and <br /> bottom of lower tube,valve length. (D) r <br /> (W)= 150 <br /> (U)= 149 Upper <br /> Tube <br /> Distance from the 71 SO inlet tube flange to the bottom _j <br /> of the tank. Note:If a tank bottom protector is present it 1� <br /> may be necessary to add this thickness to dimension <br /> (OPW 6111 &61 TP models add 0.6") (W)Valve <br /> (B)= 154 1/2 Length, <br /> bottom of t <br /> From the tank calibration chart provided by tank manu- cut <br /> '1 <br /> facturer find the dipstick number(Y)which corresponds <br /> to the 100%volume. (B) <br /> (Y)= 11,627 To Tank <br /> (Y) <br /> 1. To determine shut-off percentage: Tank <br /> Subtract upper tube length (D)from distance to tank (U)Valve Chart <br /> bottom (B) Length, 100% <br /> (X)= (B)—(D)-2"=154 1/2-74-2=78 1/2 top of cut Volume �I <br /> Dipstick <br /> 1 <br /> Using the tank calibration chart provided by the tank , <br /> manufacturer determine the tank capacity at the cal- <br /> culated (X) dimension and the 100%volume(Y)tank ?' <br /> capacity. 1 <br /> (X)tank capacity in gallons= 10,627 <br /> (Y)tank capacity in gallons= 11,627 <br /> SO%=(X)capacity/(Y)capacity x100= 91.4 <br /> Note: The overfill valve must be installed per AM require- <br /> ments and all applicable local,state,and national codes. If <br /> the overfill valve is set above the allowable shut-off percent- <br /> age the overfill valve must be removed and replaced. For <br /> reference 40 CFR part 280 Subpart B Section 280.20 overfill <br /> valves should be set to a maximum of 95%. <br /> 21 <br />