Laserfiche WebLink
6.0 - SITE SECURITY AND CONTROL <br />6.1 Work Zones <br />Restricted Site areas will include, but not necessarily be limited to, the following zones: <br />Exclusion Zone or Hot Zone - any area where contamination is either known or likely to be <br />present in concentrations that could pose a threat to human health and safety or that potential for <br />harm to personnel exists because of the type of work activities being conducted. Appropriate PPE <br />and warning signs should be utilized in this area. <br />Contamination Reduction Zone - any area where workers conduct personal and equipment <br />decontamination. <br />Support Zone - areas where access is controlled, but the chance to encounter hazardous materials <br />or conditions are minimal. <br />Access to the work zones will be controlled by work zone delineators (e.g. traffic cones, flags, vehicles, <br />DOT approved devices, temporary or permanent fencing, and/or safety barrier tape). Figure 6-1 is an <br />example of a work zone. Additionally ATC employees should follow the requirements of the Employee <br />Health and Safety Policy Manual, Policy No. 36, Work Zones in Traffic Areas for additional information. <br />In the event on-site personnel must upgrade their personal protective equipment, the work zones may <br />require substantial modification in order to provide for the safety of nearby personnel not associated with <br />this work. Any upgrade level will be communicated by the Site Supervisor to the PM. The PM will then <br />inform the RSC of this occurrence. <br />Level of Protection Required Protective Equipment (specify <br />exact type, e.g. nitrile gloves) <br />Exclusion Zone Level D Respirator: None <br />Filters/Cartridges: <br />Boots: Steel toe <br />Inner Gloves: Latex or Nitrile <br />Outer Gloves: Leather or canvas <br />Protective Coverall: <br />Hard Hat: Yes <br />Eye Protection: Safety glasses <br />Other: <br />Work Zone <br />HASP Level III <br />Rev. 01 — (June 11, 2007) 6-1