COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

Kennedy/Jenks Consultants each proposed well, boring, or excavation location. Obtain signatures from each private or public utility owner to document clearance on the each form, as required. At all locations where drilling, probing, or well installation will be performed, an air knife or similar form of suction potholing will be performed to assess possible underground utilities in the upper 6 to 8 feet of soils (depending on local conditions and expected depth of utilities). Potholing is required at all drilling locations, except in remote areas where the likelihood of encountering underground utilities is very low and only as approved by a Risk Manager, Resource/Operations Manager or Officer of the company familiar with underground utilities. (Note: Use of an air knife will be appropriate for most invasive drilling and probing work, but may not be appropriate for certain activities like very shallow borings (less than 1-foot deep), certain hand-auger borings, remedial injections using probe equipment, and test pitting.) Case-by-case exceptions for activities may be provided. Should an underground line or pipe or other obstruction be encountered unexpectedly or disturbed (broken, damaged, or undermined) immediately discontinue invasive activities and contact the Project Manager. If the Project Manager cannot be reached, contact an officer of Kennedy/Jenks Consultants. Secure the area to prevent further disturbance/damage. When clearing the site for utilities, ALWAYS REMEMBER TO LOOK UP for overhead utilities. Kennedy/Jenks Consultants will direct its subcontractors to limit the proximity of equipment to overhead power transmission lines according to the following schedule: Power Line 50 kilovolts (kV) or below 50 KV - 200 kV 200 KV - 350 kV 350 KV - 500 kV 500 kV - 750 kV 750 kV— 1,000 kV Distance from Power Line 10 feet 15 feet 20 feet 25 feet 35 feet 45 feet If the voltage of a power line is unknown, assume it is 1,000 kV. 5.1.8 Other Safety Considerations When working at the site, personnel should be aware of the following situations or activities: Vehicle, truck, and equipment traffic on residential streets and nearby service roads. Parcel maps show that East Worth Street is within the Site boundary; however it is possible that the work may require an encroachment permit from the City of Stockton. Work on East Worth will likely require traffic control. Use barricades, signage, and/or a traffic control plan (such as Caltrans Manual of Uniform Traffic Control Devices, most recent update), where appropriate. Kennedy/Jenks Consultants personnel are NOT trained in and are NOT authorized to set up traffic control or work as a highway flagger. Working with hand and small power tools. Utilize tools only for the purpose for which they were designed. Inspect all tools and equipment before they are used. Immediately BNSF Mormon Yard — Soil Sampling Site-Specific Health and Safety Plan Mormon Yard, Stockton, California © 2016 Kennedy/Jenks Consultants Page 12 Ilsfocadlprojectslts-proj1201311365020.01_bnsf stockton work planI2016 hrsc work plan appendiceslappendixb_hasp 2016_hasp_2015content_final docx