Laserfiche WebLink
Page 4/11 <br /> 4 Safety Data Sheet (SDS) <br /> OSHA HazCom Standard 29 CFR 1910.1200(g)and GHS Rev 03. <br /> Issue date 11/01/2015 Reviewed on 11/01/2015 <br /> -.Trade-name:.NctEtch E2 <br /> Additional information about design of technical systems:No further data;see section 7. <br /> Control parameters: <br /> Components with occupational exposure limits: € <br /> i 1310-73-2 Sodium Hydroxide <br /> PEL j Long-term value:2 mg/m' <br /> REL Ceiling limit value:2 mg/m' <br /> j TLV Ceiling limit value:2 mg/m' <br /> Additional information1 111: The lists that were valid du11 ring the creation of this S 11 DS were used as basis. <br /> Exposure controls: <br /> Personal protective equipment: <br /> General protective and hygienic measures: <br /> The usual precautionary measures for handling chemicals should be followed. <br /> Keep away from foodstuffs, beverages and feed. <br /> Immediately remove all soiled and contaminated clothing and wash before reuse. <br /> Wash hands before breaks and at the end of work. <br /> Avoid contact with the eyes. <br /> 1 Avoid contact with the eyes and skin. <br /> Breathing equipment: <br /> In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer <br /> exposure, use respiratory protective device that is independent of circulating air. <br /> Protection of hands: <br /> l , <br /> Protective gloves <br /> 1 , <br /> The glove material has to be impermeable and resistant to the product/the substance/the preparation. <br /> Due to missing tests no recommendation to the glove material can be given for the product/the <br /> preparation/the chemical mixture. <br /> r Select glove material based on penetration times, rates of diffusion and degradation. <br /> Material of gloves: J <br /> The selection of the suitable gloves does not only depend on the material, but also on further marks of <br /> quality and varies from manufacturer to manufacturer. As the product is a preparation of several <br /> substances, the resistance of the glove material cannot be calculated in advance and has therefore to <br /> be checked prior to the application. <br /> Penetration time of glove material: <br /> The exact break-through time has to be determined and observed by the manufacturer of the protective <br /> gloves. <br /> 99 (Contd.on page 5) j <br /> US.—J, <br />