COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

SANAOAQUIN Enviro antal Health Department COUNTY Gates and doors shall be equipped with self-closing and self-latching devices to keep them securely closed. Gates and doors shall open outwardly away from the pool except where otherwise prohibited by law. Hand activated door or gate opening hardware shall be located at a height no lower than 42 inches but no higher than 44 inches above the deck or walkway. The pool enclosure shall have a least one means of egress without a key for emergency purposes. Gates shall meet 3119B.2 of California Building Code, Title 24. One guarded jet drinking fountain shall be provided for the first 250 pool users and an additional fountain shall be provided for each additional 200 pool users unless water is available at adjacent living quarters, or in an adjacent building such as clubhouse or recreational facility. 10.A flowmeter must be installed on a horizontal straight run of pipe with a minimum of 10 pipe diameters before and 4 pipe diameters after the flowmeter. It should be positioned after the filter and before the heater. I may be installed after the heater, if a great enough distance can be maintained so that heated water will not damage the flowmeter. 11. Depth markers required at maximum depth, minimum depth, each end, break in slope, on perimeter at increments not exceeding 25 feet. Pool width greater than 20 feet: Slip-resistant depth markers required on edge of deck. Depth markers shall have numerals a minimum of 4 inches in height and of color contrasting with the background, and be marked in units of feet and inches. Abbreviations of FT and IN may be used in lieu of feet and inches; and be slip resistant when they are located on the pool deck. 12 The sump for backwashing the filtration system must be sized to meet the flow. Provide calculations for the sump to this department. Provide the EHD with a photometric plan of the deck area. An adequate amount of deck lighting shall be provided, which is at least three-foot candles. All suction outlets must be hydraulically balanced and symmetrically plumbed through one or more "T" fittings, and separated by a distance of at least three feet in any direction between the suction outlets. . Pipes shall be sized so flow velocity of piping systems including all parts and fittings other than inlet devices or venturi throats shall not exceed 6 feet per second in any suction and 8 feet per second in any portion of the return system. 16.31126.3 Where perimeter overflow systems are not provided, a bull-nosed coping or cantilevered decking of reinforced concrete, or material equivalent in strength and durability, with rounded slip resistant edges shall be provided. The overhang for either bull-nosed coping or cantilevered decking shall not exceed 2 2 of 3