Laserfiche WebLink
Bonded Sump Entry Fitting = Termination Style <br /> for Fuel Handling applications <br /> Installation and Application Instructions <br /> 1 . Determine entry hole location and cut entry hole in sump wall using appropriate " C " dimensions in Table 1 . <br /> 2 . Using 40-60 grit fresh emery cloth or sand paper, sand the sump wall surfaces , inside and outside , to the diameter of the <br /> alignment rings . All glazed surface must be removed . Once finished sanding , remove all dust from the sanded area . <br /> 3 . Place two alignment rings on sump entry fitting and insert through sump wall from outside the sump . Locate the 1/4 inch <br /> threaded outlet to the desired angular location . <br /> If this fitting is used in an Open (Drainage) System , locate the 1/4 inch threaded outlet in the 6 o' clock position . <br /> Leave '/4 inch plastic threaded outlet protector in place until 1/4 inch fitting installation . <br /> 4 . Dry fit primary pipe and rotate the two rings until the desired angle is reached . Maximum allowable offset is 5° . <br /> Make alignment marks on the rings , the sump entry fitting , and the sump wall . Be sure to mark the rings so they can be <br /> placed in the same location and sequence during bonding . <br /> SUMP WALL �\ <br /> OUTSIDE <br /> SUMP <br /> INSIDE <br /> SUMP A <br /> B <br /> 7 <br /> C <br /> HOLE <br /> TABLE I Fitting DIADimensions <br /> — <br /> Size A B C <br /> Inch Inch Inch Inch <br /> 3 x 2 6 . 88 4. 00 4. 00 ENTRY TERMINATION <br /> RETAINING ALIGNMENT FITTING BODY <br /> 4x3 6 . 88 4. 00 5 . 00 RING RINGS <br /> NOTE: These fittings can only be bonded to <br /> flat walled , fiberglass sumps . DO NOT install <br /> on thermoplastic or round sumps . <br /> ,' 16 Fiber Glass Systems <br />