Laserfiche WebLink
stat . <br /> e <br /> WATER HEATERS <br /> Recovery Ratings <br /> Model Input Rate Recovery in US Gallonsthr or LitersAe at Indicated Temperature Rlse in Fahrenheit or Celsius <br /> 15,100 BTWh .F 30 40 50 65 70 80 90 100 110 120 130 140 <br /> SBL7576NE`• GPH 243 1112 146 121 leo 91 1 gt 73 66 61 56 52 <br /> 228W °c 17 22 28 33 39 44 So 56 61 67 72 78 <br /> LPH 919 689 551 459 394 345 316 276 251 230 212 197 <br /> 75.100 BNAI 'F 3C 40 50 60 70 80 90 100 110 120 130 140 <br /> 6B11001bNE' GPH 246 184 147 123 105 92 82 74 67 61 57 53 <br /> 22 RW oc 17 22 28 33 39 .4 50 56 61 67 72 ]8 <br /> LPH 930 698 558 465 399 310 279 254 233 21S 199 <br /> `Recovery rating based on 81%thermal efficiency <br /> "Recovery rating based on 80%thermal efficiency <br /> Dimensions <br /> Model Bntts A B G D E F 5 H I X L M AppardLshl�g <br /> Weight <br /> SBL7516XE Inches 62-1/16 58 1 29-12 25-1!4 15-7/8 4 15-1/4 16 2 1 1 112 g31.8 <br /> 285lbs <br /> CM 157.6 147.3 74.9 64.1 4D.3 10.2 38.7 40.6 5.1 NPT NPT 129.2.log <br /> 70-1/2 66472 30-15/16 24/4 15-3/16 4 15-3/4 I6 1-1/4 1-1/412 3501hs <br /> 179.1 158.9 78.6 70.5 38.6 10.2 40 40.6 3.2 NPT NPT 158.8 Xe <br /> K <br /> HOT WATER <br /> OUTLET F K TOP VIEW <br /> COLO WATER <br /> INLET H <br /> 4 <br /> J <br /> TUR <br /> TEMPERAAEAND 1 <br /> TEM PRESSURE <br /> DRAIN REUEF VALVE <br /> VALVE + <br /> ~ O NOT C <br /> G <br /> 8 <br /> A iL DRAIN VALVE <br /> ElT� L GAS INLET <br /> IM <br /> OL <br /> SPECIFICATION <br /> Water heater(s)shall be Model as manufactured by State Water Heaters or an approved equal.Water heater(s)shall be of <br /> glasslined design,equipped to burn gas and design certified by UL and shall be approved by the National Sanitation Foundation(with <br /> optional leg kit).Heaters must meet all applicable energy codes and comply with ultra-low NOx emissions of 14 l or 20 ppm.Heaters shall have an <br /> input rating of_BTU/H and a recovery capacity of_GPH at a temperature rise of 100°F with a storage capacity of_gallons.Heater <br /> shall be equipped with a 2-3/4"x 3-3/4"boiler-type handhole cleanout and shall have a working pressure of 150 psi.Heater(s)shall be provided <br /> with an automatic gas shutoff device and safety shutoff in event pilot flame is extinguished;a gas pressure regulator set for the type of gas supplied; <br /> an approved draft hood,and extruded anode rod rigidly supported for cathodic protection.A CSA Certified and ASME Rated T&P Relief Valve shall be <br /> furnished and installed by the manufacturer.The tank shall be foam insulated.The outer jacket shall have a baked enamel finish over a bonderized <br /> undercoating.Fully illustrated instruction manual and parts list to be included.All internal surfaces of the heater(s)exposed to water shall be glasslined <br /> with an alkaline borosilicate composition that has been fused-to-steel by firing at a temperature range of 1400°to 1600°F.Heater shall have a three year <br /> limited tank and one year limited parts warranty against corrosion and tank failure due to sediment buildup as outlined in the written warranty.Heater(s) <br /> shall be design certified by UL.Operation of the heater in a closed system where thermal expansion has not been compensated for with a properly sized <br /> expansion tank will void the warranty. <br /> FOR MORE I• I 11 1004165.0024 <br /> Page 2 of 2 <br /> www.statewaterheaters.com 1800-365-0024 Toll-Free USA SCOSS01712 <br />