COMPLIANCE INFO_2019 - Laserfiche WebLink

Home Browse Search

UNDERGROUND STORAGE TANK MONITORING SYSTEM CERTIFICATION FORM (Page 4 of 6) VIII . MONITORING SYSTEM AND PROGRAMMING This section must be completed if a monitoring panel is used to perform leak detection monitoring. Y N TNA Are the visual and audible alarms operational ? N El 1:1 Were all sensors visually inspected for kinks and breaks in the cables and for residual buildup to ensure that floats move freely, ❑ ❑ functionally tested , and confirmed operational? Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with ❑ ❑ their proper operation? Was monitoring system set-up reviewed to ensure proper settings ? ❑X ❑ ❑ Was the monitoring panel's backup battery visually inspected , functionally tested , and confirmed operational? Q ❑ ❑ Does the flow of fuel stop at the dispenser if a leak is detected in the under-dispenser containment? Q ❑ ❑ Does the turbine automatically shut down if the piping secondary containment monitoring system fails to operate or is electrically 0 ❑ ❑ disconnected? Does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak? ❑ ❑ Which sensors initiate positive shut down? (Check all that apply.) 0 Sump 0 Under-Dispenser Containment If alarms are relayed to a remote monitoring station, is all communications equipment (e. g . , modem) operational? ❑ ❑ ❑X I For any answer of W' above, describe in Section IX how and when these deficiencies were or will be corrected. r 1X. COMMENTS DIESEL SIDE USES LINE TESTING IN L ; UE OF SHUTDOWN REQUIREMENTS . E E X. IN -TANK GAUGING TESTING QX Check this box if tank gauging is used only for inventory control . (Do not complete this section.) F] Check this box if NO tank gauging equipment is installed . (Do not complete this section.) 7YIN NA This section must be completed if in-tank gauging is used to perform leak detection monitoring. Has all input wiring been inspected for kinks and breaks in the cables and for proper entry and termination , including testing for ❑ ❑ ❑ round faults? ' Were all in-tank gauging probes visually inspected for damage and residue buildup to ensure that floats move freely, functionally ❑ ❑ ❑ tested , and confirmed operational? Was accuracy of system's product level readings tested ? ❑ ❑ ❑ Was accuracy of system's water level readings tested ? ❑ ❑ ❑ Were all probes reinstalled properly? ❑ ❑ ❑ Were all items on the equipment manufacturer's maintenance checklist completed? ❑ ❑ ❑ For any answer of "M' above, describe in Section XI how and when these deficiencies were or will be corrected. XI . COMMENTS Y = Yes, N = No, NA = Not Applicable