Laserfiche WebLink
STEP 6: APPLY GREASE TO DROP TUBE <br /> Apply black cooly grease to the inside diameter of the <br /> upper drop tube. Make sure coverage is completely <br /> around the tube as shown in Figure 6. - <br /> i <br /> a <br /> Figure 8 <br /> NOTE.Testable inlet tube must have cable port in <br /> line with float. Testable inlet Mabe bottoms out on <br /> stop,it does not bottom out on inlet Range. See Fig- <br /> ure 8A <br /> Figure 6 <br /> STEP 7: APPLY GREASE TO POLYPAK SEAT. <br /> Ensure that the polypak seal is installed on the inlet <br /> tube with the fip up as shown in Figure 9. Apply black <br /> moly grease to the polypak as shown. Make sure cover- <br /> age is completely around the polypak seal. <br /> € y <br /> E=nsure polypak <br /> lip is up Cable port must be in <br /> line with float <br /> r' a <br /> Inlet YI lr <br /> Tube h, raiyok <br /> Figure 8A <br /> `! Testable Models Only <br /> +4liply grease <br /> around polypak SEE PAGE 8 FOR INSTRUCTIONS USING THE 77SO- <br /> TOOL• <br /> Figure 7 <br /> SEE PAGE 9 FOR INSTRUCTIONS USING THE 71 SO- <br /> STEP 8: INSTALL INLET TUBE TOOT C. <br /> Insert the inlet tube into the upper tube until the upper <br /> tube seats against the flange on the inlet tube. Ensure SEE PAGE 10 FOR INSTRUCTIONS USING THE uS <br /> polypak is inserted evenly and stays in inlet tube TOOLCT. <br /> groove. Note: testable 77SO models ending with u`T"r+equire the <br /> 7150-TOOLCT ar modified 7150-TOOL or 71 SO-TOOLC <br /> 7 <br />