Laserfiche WebLink
Page 1 of 2 <br />Benjamin Escotto [EH] <br />From: <br />Benjamin Escotto [EH] <br />Sent: <br />Monday, September 24, 2012 8:44 AM <br />To: <br />'Linda Knowles' <br />Subject: RE: Follow up of Medical Waste Inspection <br />Linda, <br />I too don't know why I didn't receive this last time, but I now reviewed the documentation. It is sufficient for <br />compliance for violation #1. All that is left is the corrections that Jeremy needs to submit. <br />Ben Escotto, Senior REHS <br />San Joaquin County Environmental Health Department <br />1868 E. Hazelton Ave., Stockton, CA 95205 <br />Email: bescotto@sicehd.com Phone (209) 468-3178 <br />EHD Website:.http:/lwww.sigov.org/ehd Fax (209) 468-8392 <br />From: Linda Knowles[mailto:L.Knowles@dameronhospital.org] <br />Sent: Monday, September 24, 2012 8:02 AM <br />To: Benjamin Escotto [EH] <br />Cc: Jeremy McIlvain; Mark Koenig <br />Subject: FW: Follow up of Medical Waste Inspection <br />Ben, not sure why you had not received this that I sent last Wed regarding the thermometer calibration. <br />Please confirm receipt and acceptance to satisfy violation #1. Thank you. <br />Linda Knowles, MS, RN, CIC <br />Nurse Epidemiologist <br />Dameron Hospital Association <br />525 West Acacia Street <br />Stockton, CA 95203 <br />Phone (209) 461-3163 <br />Fax (209) 944-5429 <br />From: Linda Knowles <br />Sent: Wednesday, September 19, 2012 11:19 AM <br />To: 'Benjamin Escotto [EH]' <br />Cc: Jeremy McIlvain; Mark Koenig <br />Subject: Follow up of Medical Waste Inspection <br />Good Morning Ben. <br />I have previously sent you information regarding the spore testing indicating that the expiration date is <br />included in each lot number. Please indicate that this has satisfied the requirement for violation #6 on the <br />report. I would like to address #1 which stated that the calibration document submitted does not indicate <br />that the thermometer was calibrated. Perhaps because the copy was not the best, it was not obvious to <br />us until looking closer that the information is actually included on the San -I -Pak Calibration report that we <br />submitted --in the section on Calibration, it stated "Calibrated with Fluke 51 thermometer'. Attached <br />9/24/2012 <br />