Laserfiche WebLink
ENTRANCES & STOREFRONTS <br />Section 08410 <br />15-1207 <br />PART 1 - GENERAL <br />1.01 INCLUSION OF OTHER CONTRACT DOCUMENTS <br />A. The General Conditions, Supplementary Conditions and Division 1 are fully applicable to this <br />Section, as if repeated herein. <br />1.02 RELATED WORK SPECIFIED ELSEWHERE <br />A. Section 04300, Unit Masonry System. <br />B. Section 05400, Cold Formed Metal Framing. <br />C. Section 06100, Rough Carpentry. <br />D. Section 07900, Joint Sealants. <br />E. Section 08710, Finish Hardware. <br />F. Section 08800, Glazing. <br />G. Section 09200, Lath and Plaster. <br />H. Section 09250, Gypsum Wallboard. <br />1.03 QUALITY ASSURANCE <br />A. Use only new materials and products, unless existing materials or products are specifically <br />shown otherwise on the Drawings to be salvaged and re -used. <br />B. Use materials and products of one manufacturer whenever possible. When aluminum <br />framing is part of a building enclosure system, including entrances, entrance hardware, <br />windows, curtain wall system and related products, provide building enclosure system <br />products from a single source manufacturer. <br />C. All materials, components, assemblies, workmanship and installation are to be observed by <br />the Owner's Project Inspector. Work not so inspected is subject to uncovering and <br />replacement. <br />C. Qualifications: <br />1. Installer Qualifications: Installer experienced (as determined by contractor) to perform <br />work of this section who has specialized in the installation of work similar to that required <br />for this project and who is acceptable to product manufacturer. <br />2. Manufacturer Qualifications: Manufacturer capable of providing field service <br />representation during construction, approving acceptable installer and approving <br />application method. <br />E. Pre -Installation Meetings: Conduct pre -installation meeting to verify project requirements, <br />substrate conditions, manufacturer's installation instructions, and manufacturer's warranty <br />requirements. <br />