Laserfiche WebLink
TESTABLE PROCEDURE ONLY,FOR STANDARD MOD- STEP 3T: DETERMINE CABLE LENGTH <br /> ELS,PROCEED TO NEXT PAGE. Faun cable along upper tube and over the top plate on <br /> the float bracket as shown. With the float in the clown <br /> STEP 11T.- INSTALL SOCKET ADAPTOR ASSY position has shown in Figure 3T)align loop in cable with <br /> Put cable thru threads in inlet tube and out thru cable rivet and top hole in float bracket. Use the rivet as a <br /> port on side of inlet tube. Thread the socket adaptor template to size the loop in the cable and pull cable <br /> assembly finger tight into the inlet tube. Note; theca- tight and crimp ferrule with crimping tool 1 pliers onto <br /> bie porton the inlet tube must be in line with the float cable at this location. Trim excess cable with wire cut- <br /> as shown previously in Figure 8A. ter/scissors. For reference,from the seam where the <br /> upper tube and valve body meet to the end of the cable <br /> Socket � <br /> aciaptnafter trimming will require approximately 3.5"of cable.�, I <br /> assembly Cable over float bracket <br /> Cable <br /> part Seam ; <br /> i <br /> F1.9are3T <br /> Figure 7T STEP 4T: ATTACH CABLE TO FLOAT BRACKET <br /> Ensure cable is over the float bracket. Using the sup- <br /> plied rivet align loop in cable with top hole in float <br /> STEP 2T: PASS CABLE THRU FERRULE bracket and pass rivet thru cable loop and float bracket <br /> Pass cable thru ferrule. Loop cable and then pass cable hole. Using rivet tool for 118'°dia mandrel attach rivet <br /> back thru ferrule. Keep ferrule loose until cable length and cable to the float bracket. See.last page for list of <br /> is determined in the next step. Note. if cable end frays replacement cable parts, <br /> it may be necessary to trim the cable again to pass thru <br /> ferrule. �. Attach rivet to tap hole <br /> 118"mandrel <br /> rivet <br /> \ 9 <br /> 'ri <br /> l ` Z'�i �'•l - <br /> Ferrule }� <br /> Figure 4T <br /> Trim <br /> cable STEP 5T:ENSURE PROPER CABLE OPERATION <br /> _�--� .~` - <br /> after Unthread the socket adaptor assembly from the inlet <br /> tube and ensure float and poppet move freely when <br /> step 3T Loop socket adaptor assembly is pulled on. It should only <br /> require 3"to 4"of movement in orderto actuate the <br /> Figure 2T float and poppet. Thread socket adaptor assembly fin- <br /> ger tight into inlet tube after testing. <br /> 13 <br />