Laserfiche WebLink
2 <br />Performance Primary operating pressures to 300 psi (20 bar) <br />Continuous operating temperature to 150°F (66°C) <br />Containment system pressures to 40 psi (2.9 bar) <br />Individual system components may not have the same ratings as the pipe. Refer to the <br />detailed product information for the specific components to determine the pressure rating <br />for the system as a whole. <br />Composition Primary pipe:Filament-wound fiberglass reinforced epoxy pipe with integral epoxy liner <br />and exterior coating. When classified in accordance with ASTM D2310 and ASTM <br />D2996, the pipe meets the following cell limits: RTRP 11CX-5430. <br />Pipe containment:Filament-wound fiberglass reinforced epoxy pipe. <br />Interstitial space:Dry sand particles (10-20 mesh) secured in place with adhesive <br />backed tape. <br />Fittings:Compression molded or filament-wound fiberglass reinforced epoxy primary <br />fittings. Containment fittings are molded. <br />Adhesive:Ameron B20, PSX™•20 or PSX™•34 ambient-cure, two-part epoxy for all services <br />(including alcohols and MTBE). <br />Joining system Primary:Bell and spigot taper/taper adhesive-bonded joint <br />Containment:Adhesive-bonded clamshell fittings. Parts are compression molded for <br />exact fit and match. Material is identical to primary fittings and is fully Listed by U.L. for all <br />services, including use in MTBE fluids. <br />Pipe lengths Standard 20 ft. (6.1 m) random lengths 17 to 21 ft. (5.2 to 6.4 m) <br />and 27 ft. (8.2 m) random lengths 25 to 27 ft. (7.6 to 8.2 m) <br />Other lengths up to 42 ft. available upon request. <br />Fittings Primary–Adapters: bell x NPT male1 Flange stub ends1 <br />Adapters: bell x NPT female2 Isolation bushings1 <br />Adapters: spigot x NPT female2 Nipples2 <br />Adapters: spigot x NPT male2 Reducer bushings1,2 <br />45°elbows1 Repair couplings1 <br />90°elbows1 Sleeve couplings2 <br />End caps1 Tees1 <br />Flange rings1 Dispenser pan penetration fittings1 <br />Containment–45°elbows1 Couplings1 <br />90°elbows1 Tees1 <br />Termination sleeves1,3 <br />1 Molded fitting <br />2 Filament-wound fitting <br />3 2-inch available with or without test valve. 3- and 4-inch available only with test valve