SR0081937_OWTS - Laserfiche WebLink

Home Browse Search

Table of Contents 2 Introduction/Precautions/Operating Parameters 9 Operation and Maintenance/Storage Tank Information 3 "We Will Not Compete in the Race to the Bottom" 10 Routine Maintenance 4 Installation Instructions 11 Fittings and Connections 5 Installation Instructions/Optional Timer 12 Sample System Drawings 6 How Reverse Osmosis Works/Maintenance Frequency 13 Permeate Pump (Optional) Information 7 Common Components 14 Reverse Osmosis Troubleshooting 8 Start Up/Sanitization 15 Warranty/LeakSmart 16 General Information I , ild A leak detection device with automatic shut off must be ins ae ulTrwriillyapplication where leak may cause water damage. We offer simple cost effective POU leak detection systems to high tech whole house protection. Do not install this device without leak protection' . INTRODUCTION/PRECAUTIONS Data herein is provided as a courtesy and is subject to change without notice. This reverse osmosis water filtration system uses multiple filtration technologies to reduce the levels of contaminants in the water supply. For proper operation, it is essential to confirm that the influent water supply complies with the following operating param- eters. Failure to adhere to the operating parameters may negatively impact system performance and will void the warranty. DO NOT USE WITH WATER THAT IS MICROBIOLOGICALLY UNSAFE OR OF UNKNOWN QUALITY, WITHOUT ADEQUATE DISINFECTION BEFORE OR AFTER THE SYSTEM. Must be potable 40-60 to 80 psi (3.45-5.5 bar)* 40-100°F (4.4-38°C) <2000mg/L (2000 ppm) 4-11 1 mg/L (Change carbon pre-filters more often if chlorine exceeds 1 mg/L) 10 GPG (171 mg/L) (soften or expect more frequent membrane changes) 5 NTU Maximum Less than 0.1 mg/L Less than 0.1 mg/L Less than 0.05 mg/L *This reverse osmosis water filtration system requires adequate pressure to operate. As the TDS level increases, the influent pres- sure requirement increases. In general, this system requires a minimum of about 40 psi at the membrane inlet with <500 mg/L TDS. With 2000 TDS, the system will need about 55-60 psi to achieve minimal acceptable performance. System must be installed and maintained by a qualified, experienced, licensed and bonded technician. It must be installed in a loca- tion protected from sunlight and not subjected to freezing or impact. The inlet pressure must be regulated to within the operation- al parameters. Use a dedicated pressure boosting device or regulator to maintain proper water pressure. Install and maintain re- dundant, adequate leak protection devices and or methods. Install to a cold water feed only. This drinking water system is designed for aesthetic water improvement only and will not protect against disease causing or re- move naturally occurring bacteria. It must be used with a potable water supply only. Installation must comply with all local and state laws, regulations and codes. When properly applied, installed and maintained, this reverse osmosis system will provide consistent, great tasting water that can be used for a wide variety of purposes. The system is made with plastic housings and components that will naturally degrade over a highly variable period of time. To re- duce the risk of damage, under normal conditions, it is recommended that the systems plastic housings and components be re- placed at 5-10 year intervals. Ak WARNING: Cancer and Reproductive Harm- www.P65Warnings.ca.gov This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. Water Supply: Feed Water Pressure: Water Temperature Range: Total Dissolved Solids (TDS): pH Limit: Chlorine: Hardness: Turbidity: Iron: Hydrogen Sulfide: Manganese: 2