COMPLIANCE INFO_2022 - Laserfiche WebLink

Home Browse Search

i PHIVITE j j Franklin Fueling Systems 85000-1 Series Spill Containers — Fill and Vapor Installation Instructions I Introduction Phil-Tice Spill Containers (Fill and Vapor) are designed to provide easy installation and/or removal of the spill container without the need for timely excavation, cutting concrete or disassembly of secondary containment covers. Phil-Tite's drain valves drain directly into the tank, providing a fast and complete removal of excess liquid spilled during a product delivery operation while maintaining a reliable seal that is vapor and liquid tight, eliminating leaks Into the environment. All Phil-Tite's Spill Containers have straight machined threads (female threads where the spill container screws onto the riser adaptor.) All Spill Containers are shipped completely assembled and CARB Phase I EVR '.. Tested and Certified. No field assembly is required. The new 85000-1 Series Spill Container can be '.. used as a direct replacement for a correctly Installed 85000 series EVR Spill Container without cutting y concrete or changing the tank riser. Note: On EVR certified systems the drop tube is installed under the fill spill container. '.. INSTALLATION : For New UST Installation and/or UST's being Upgraded Step 1 — Determining The Correct Riser Length for Spill Container Installation I 1 , Method 1 - Cut and thread your steel tank riser to allow approximately 18 1/8" (Fill riser), and/or 18" (Vapor riser) from top of the tank riser to finish grade. This measurement assumes an M/F 4X4 Riser Adaptor will be installed. Also this measurement will allow the water tight cast iron lid to seat properly into the stainless steel sleeve when the spill container is installed. I See Figure 1 . 2. Method 2 - With the MIF 4X4 Riser Adaptor installed onto the Tank Riser you should have 16 3/8" (Fill), and 16 1 /4" (Vapor) measured from the top of the M/F 4X4 riser adapt and/or to finish grade and/or top of the diamond plate manway cover. This measurement will allow the water tight cast iron lid to seat properly Into the stainless steel sleeve. See Figure 1 . 3. Method 3 - Using a tape measurer, measure from top of the tank to finish grade and/or top of the manway cover. This is measurement "A". For 85000-1 Fill Spill Container subtract 18 1 /8" from measurement "A" to equal XXX". "A" — 18 1 /8" = xxx". For the 85000-1 vapor spill container subtract 18" from "A". The results are the length of your risers measured from the top of the tank. Cut and thread one end of your 4" riser and dry fit it Into the tank bung. PHIL- iITE Measure your riser (Installed into the tank bung) from top of tank to the dimension above, mark your riser. Cut this riser on the mark made above and thread this end. See Figure 1 . Franklin Fueling Systems lull 3768 Marsh Road Mdd'son, WI53718, USA Tet +1608 838 8786 Tat USA 6 Canada 1 800 225 8787 Tet Moko 001 NO 38 ®2007 FFS 602019001 Rev. / nxWJ nlduilue(ny. 7t 7610 1 of 8