ARCHIVED REPORTS_2020 ADDITIONAL SITE ASSESS RPT

Home Browse Search

NARRATIVE Lab Order: Project ID: V060910 SAN JOAQUIN COGEN LLC General Qualifiers and Notes Caltest authorizes this report to be reproduced only in its entirety. Results are specific to the sample(s) as submitted and only to the parameter(s) reported. Caltest certifies that all test results for wastewater and hazardous waste analyses meet all applicable NELAC requirements; all microbiology and drinking water testing meet applicable ELAP requirements, unless stated otherwise. All analyses performed by EPA Methods or Standard Methods. Dilution Factors (DF) reported greater than '1' have been used to adjust the result, Reporting Limit (RL), and Method Detection Limit (MDL). All Solid, sludge, and/or biosolids data is reported in Wet Weight, unless otherwise specified. Filtrations performed at Caltest for dissolved metals (excluding mercury) and/or pH analysis are not performed within the 15 minute holding time as specified by 40CFR 136.3 table II. Results Qualifiers: Report fields may contain codes and non-numeric data correlating to one or more of the following definitions: ND - indicates analytical result has not been detected at or above the Reporting Limit (RL), or at above the Method Detection Limit (MDL) when it is included on the report and is not otherwise noted. RL - Reporting Limit is the quantitation limit at which the laboratory is able to detect an analyte. An analyte not detected at or above the RL is reported as ND unless otherwise noted or qualified. For analyses pertaining to the State Implementation Plan of the California Toxics Rule, the Caltest Reporting Limit (RL) is equivalent to the Minimum Level (ML). A standard is always run at or below the ML. Where Reporting Limits are elevated due to dilution, the ML calibration criteria has been met. MDL - The Method Detection Limit is defined as the minimum measured concentration of a substance that can be reported with 99% confidence that the measured concentration is distinguishable from method blank results. J - reflects estimated analytical result value detected below the Reporting Limit (RL) and above the Method Detection Limit (MDL). The 'J' flag is equivalent to the DNQ Estimated Concentration flag. B - indicates the analyte has been detected in the blank associated with the sample. SS - compound is a Surrogate Spike used per laboratory quality assurance manual. NOTE: This document represents a complete Analytical Report for the samples referenced herein and should be retained as a permanent record thereof. Qualifiers and Compound Notes Analysis Performed by BC Laboratories, Inc.; CA ELAP #1186. Some BC Labs sample and quality control results are input into Caltest's database to include in Caltest's report and EDD, as a convenience to our client. If quality control values in the two reports do not match, the BC reported value should be considered the correct value. 1 Page 3 of 8 NELAP/ORELAP Certification 4036 CA-ELAP Certification 1664 (707) 258-4000 • Fax (707) 226-1001 • e-mail: info@caltestlabs.com 1885 North Kelly Road • Napa, California 94558 without the written consent of CALTEST ANALYTICAL LABORATORY This report shall not be reproduced, except in full, REPORT OF LABORATORY ANALYSIS7/20/2020 12:33