SR0085735_SSNL - Laserfiche WebLink

Home Browse Search

Percolation Test A shallow percolation test was conducted at the test location. The soil boring discussed above was used for the percolation test hole. Percolation test procedures conformed to San Joaquin County Environmental Health Department policy. Preparation and Presaturation of Percolation Test Holes After the boring was advanced by hand auger and the soil logged, the test hole was completed for the percolation testing. Approximately two inches of pea gravel were placed in the bottom of the open soil boring, followed by a 2.0 -inch diameter PVC pipe with perforations on the bottom. Pea gravel was then used to backfill a few inches of the annular space. Live Oak presaturated the percolation test hole approximately 24 hours prior to the percolation testing. The hole was filled with water to a height of 12 inches above the bottom of the boring for the presaturation. On the day of testing, the hole was found to be intact and dry. Percolation Test Procedure Live Oak conducted the percolation test for the boring on July 27, 2022. Based on initial percolation rates observed, a one-hour test was selected. Water level measurements were taken every 10 minutes during the one-hour period. The last 30 minutes of the test were observed by Michael Suszycki, Registered Environmental Health Specialist at the San Joaquin County Environmental Health Department. An electronic well sounder with a depth accuracy of 1/100th foot was utilized for the water level measurements. The water level was measured against a fixed reference point on the well casing. Measurements were recorded on the data sheet in decimal feet. When necessary after measuring the water level, the hole was refilled with water to a level of approximately six inches above the bottom of the hole. Percolation Test Results The completed percolation test form is included in Appendix 3 of this report. The form was signed by Mr. Suszycki and indicates a percolation rate for the hole based on the final water drop observed. Per San Joaquin County Environmental Health Department's definition, a shallow percolation test hole has a depth between 18 and 42 inches; a satisfactory percolation rate for a shallow test is greater than or equal to 1 minute per inch (min/in) but less than or equal to 60 min/in drop. For the Site to utilize a standard septic system, one percolation test hole must demonstrate a satisfactory percolation rate within the proposed septic system disposal field. LOGE 2236 Page 6