Laserfiche WebLink
2. Complete Applause/InOvationTv Install and Startup <br />3. Purge 50 Gallons from each product meter. (Dispenser Only) <br />4. Calibrate and place each meter into service with Weights and Measures. <br />5. Would also like an Hourly Rate in case they need us to fill in for these guys <br />Notes & Exclusions: <br />1. Startup does not include landing of any wires. <br />2. Startup will not include troubleshooting electrical/wiring issues. <br />3. POS must be online and ready to communicate with dispensers. <br />1. Quote does not include site purge of underground product piping. <br />Veeder Root: <br />1. Install customer supplied Software and Software Enhancement Module. <br />2. Hand program System Setup, Communication Setup, In -Tank Setup, Liquid sensor setup, Pump Sensor <br />Setup, Output Replay Setup, Smart Sensor Setup, PLLD Setup, and EVR/ISD Setup. <br />3. Program per sites setup instructions, if supplied. <br />4. Install and configure TCP/IP card. <br />5. Test fuel reading connection with major oil (if applicable) <br />6. Install Veeder Root EDIM and connect to POS. <br />7. Pre-test all sensors for audible, visual, and shutdown. <br />8. Grade Map all hoses into Veeder Root and test ISD communication. <br />9. Commission Veeder Root and complete WRACO form. <br />Notes & Exclusions: <br />1. Startup does not include landing of wires <br />2. Startup will not include troubleshooting electrical/wiring issues. <br />3. Network must be online with an active port to complete TCP/IP testing procedures. <br />4. POS must be online and communicating to dispensers in order to complete grade map. <br />Pre -Monitor Testing <br />Testing: (AQMD / CUPA) <br />1. Complete Startup Monitor Certification <br />1. Test all liquid sensors <br />2. Test all smart sensors <br />3. Test fail safe <br />4. Test sensor out <br />5. Test leak detector <br />6. Test spill bucket lake test <br />7. Complete overfill prevention <br />Complete Startup Air Quality Startup Testing <br />1. TP -201.16 - Static Torque of Rotatable Phase I Adaptors <br />2. TP-201.1C/D - Leak Rate of Drop Tube/Drain Valve Assembly and Leak Rate of Drop Tube Overfill <br />Protection Devices and Spill Container Drain Valves <br />3. FORM 1 -SUMMARY OF SOURCE TEST DATA <br />4. E.O. VR -203/204 - Veeder-Root Vapor Polisher Hydrocarbon Emissions <br />5. E.O. VR -203/204 - Veeder-Root Vapor Polisher Operability <br />6. E.O. VR -203/204 - Vapor Pressure Sensor Verification Test & VST Processor Activation Pressure <br />7. E.O. VR -204 - Veeder-Root In -Station Diagnostics Balance Vapor Flow Meter Operability Test Procedure <br />8. E.O. VR -204 - Veeder-Root In -Station Diagnostics Site Shutdown Test <br />9. TP -201.6C Or EVR - Liquid Removal Test Liquid Removal Rate <br />10. TP -201.4 - Dynamic Back Pressure Test <br />11. E.O. VR -202 - Veeder-Root In -Station Diagnostics Vapor Pressure Sensor Reference Test & <br />Site Shutdown <br />