Laserfiche WebLink
® Anthon Model 401 & 403 Pass-Thru <br /> y Service and Installation Instructions <br /> •�. 99-21972-S001 Rev. A <br /> 2. Unplug molded hinge pin plug at heater access hole and remove hinge pin out <br /> through top of door. Remove heater wire from perimeter of door. <br /> 3. Heater access hole is 7" down on hinge side. Cut solid lead wires to heater and <br /> pull heater out of aluminum groove in door rail. Unplug lead wires to heater. <br /> 4. To replace heater, lay heater in track around door and reconnect heater wires to <br /> lead wires. <br /> 5. Heater leads are Black or Red and White. <br /> 6. Receptacle wires are Black or Red-, White and Green for ground. <br /> 7. If heated glass is used, cut Black and White lead wires from glass. <br /> 8. To replace glass heater leads, wire Black to Black and White to White. <br /> 9. To replace receptacle leads, wire Black or Red to Black, White to White and <br /> Green to ground. <br /> Hinge Pin Replacement <br /> NOTE: See Door Female Plug Replacement for illustration. <br /> 1. If two-piece hinge pin and receptacle is used, remove gasket and plastic, <br /> unsnap hinge pin from receptacle and remove hinge pin. Pull receptacle out <br /> from heater access hole and cut or unplug lead wires. Lead wires will be Black <br /> or Red, White and GreenNellow for ground. <br /> 2. Reverse instructions to replace. <br /> Torque Rod Replacement <br /> 1. A tipless torque rod is used. Simply insert rod through bottom access hole in <br /> door rail and push up until rod engages into bottom torque shaft. <br /> 2. To remove, lay a flat-head screwdriver parallel to hinge rail, catch edge of <br /> bottom of torque rod shaft and tap out. <br />