Laserfiche WebLink
® Model 401 & 403 Pass-Thru <br /> 0 Anthony Service and Installation Instructions <br /> Ate. 99-21972-S001 Rev. A <br /> 1. Remove Mullion cover on top back side of frame. <br /> a. To remove, insert flat-head screwdriver under back edge of zipper strip <br /> and peel back the plastic. Caution: If the zipper strip becomes damaged <br /> during this operation, replacement of the strip will be required. <br /> b. Driver is now exposed. <br /> 2. To remove driver detach the connector at the top of the driver and, cut the lead <br /> wires (red and blue) at the bottom. <br /> S � I <br /> i <br /> •;:tl:i-:1 <br /> Disconnect wire connector at Cut wires at the bottom of the <br /> top of driver(black& white) driver(red&blue) <br /> 3. Reverse instructions to replace. Follow color-coded wires: Blues to Blues, Reds <br /> to Reds, Blacks to Blacks and Whites to Whites. (Note: The red and blue wires <br /> will require electrical tape to splice them together in the field). <br /> Raceway Clip Installation or Replacement <br /> Cover <br /> Raceway <br /> Clip <br /> Raceway <br /> Groove <br /> 1. Insert flat-head screwdriver under top edge of clip and lift to remove. <br /> 2. To re-install clip, insert curved end of clip into groove in bottom of raceway, then <br /> snap clip over raceway cover. <br /> 3. To replace raceway cover, lay cover on back of raceway, then snap retainer <br /> plastic on. Insert retainer on front edge of raceway cover, then snap over bottom <br /> edge of raceway. <br />