INSTALL_2023 - Laserfiche WebLink

Home Browse Search

TESTABLE PROCEDURE ONLY,FOR STANDARD MOD- STEP 3T: DETERMINE CABLE LENGTH ELS, PROCEED TO NEXT PAGE. Run cable along upper tube and over the top plate on the float bracket as shown. With the float in the down STEP 1T: INSTALL SOCKET ADAPTOR ASSY position (as shown in Figure 3T) align loop in cable with Put cable thru threads in inlet tube and out thru cable rivet and top hole in float bracket. Use the rivet as a port on side of inlet tube. Thread the socket adaptor template to size the loop in the cable and pull cable assembly finger tight into the inlet tube. Note: the ca- tight and crimp ferrule with crimping tool/pliers onto ble port on the inlet tube must be in line with the float cable at this location. Trim excess cable with wire cut- as shown previously in Figure 8A. ter/scissors. For reference,from the seam where the upper tube and valve body meet to the end of the cable Socket after trimming will require approximately 3.5"of cable. adaptor assembly Cable over float bracket ookCable Seam port i Figure 3T STEP 4T: ATTACH CABLE TO FLOAT BRACKET Figure IT Ensure cable is over the float bracket. Using the sup- plied rivet align loop in cable with top hole in float STEP 2T: PASS CABLE THRU FERRULE bracket and pass rivet thru cable loop and float bracket Pass cable thru ferrule. Loop cable and then pass cable hole. Using rivet tool for 1/8"dia mandrel attach rivet back thru ferrule. Keep ferrule loose until cable length and cable to the float bracket. See last page for list of is determined in the next step. Note: if cable end frays replacement cable parts. it may be necessary to trim the cable again to pass thru ferrule. Attach rivet to top hole 1/8"mandrel z rivet Ferrule Figure 4T Trim STEP 5T:ENSURE PROPER CABLE OPERATION cable Unthread the socket adaptor assembly from the inlet after tube and ensure float and poppet move freely when step 3T Loop socket adaptor assembly is pulled on. It should only require 3"to 4"of movement in order to actuate the Figure 2T float and poppet. Thread socket adaptor assembly fin- ger tight into inlet tube after testing. 13