WORK PLANS - Laserfiche WebLink

Home Browse Search

410 COUNTER: Must be located on a sturdy, ievel surface able to support at least 150 lb The dispenser dimensions are 28.4- D x 10- W x 34 - H. A clearance of 4 - is required at both sides and 6" at the back and top of the machine. A 1.5 — 2" diameter hole is required for the tubing if the N2 and/or water fitter is located under the counter If you choose to utilize Bunn's Nitron2 Gas Module it Will fit under the Nitron_ Do you have a counter that meets the above requirements? (Select from Drop Down) ELECTRICAL: A 120 VAC, 15 A dedicated branch circuit is required, The receptacle must be within 6 It of the m achine. A NEtvIA 5-15R mating connector is required. Do you have the required electrical supply? (Select from Drop Down) NOT: All applIcabie electrical codes must be followed. WATER SUPPLY: An ambient water source with an operating pressure between 30 psi and 90 psi with a minimum s-upply of 2 oz. per second, and a shut-off valve is required. The shut-off valve should be located as close as possible to the dispenser. The cold-water source should be terminated with3/8 - I.D. tubing rated for a minimum of 150 psi for connection to the water filter. Similar tubing should also be used for the connection from the water filter to the dispenser. The installiqg technician will connect the water source to the water fitter and the water fidter to the dispenser, Do you have an adequate water supply with a shut off? F-7 (Select from Drop Down) NOTE: MI plumbing codes/ requirements must be abided by when connecting water supply. WATER FILTRATION: Install the water filter if applicable ) as close as possible to the Fie et the dispenser but downstream of the shut- offiatve. Allow adequate space for the installation of the water filter. The water filtration system must supply a minimum of 1,5 gpm. The dimensions for the water filter cartridge with the fitter head assembly are 4.5 ID x 15" H. The filter must be installed to a secure mounting point and accessible for service. The water filter must be installed vertically, Bunn P/N 39000.0004 0 What type of water filtration do you currentty have? (Select from Drop Down) 'Note: Bunn will install a filter (*old separately) If you do not have one. If your municipality uses Chloraniirtell to Disinfect trie water we suggest you use our Cheonernin• filter Bunn PM 39000.0014. DRAIN: If the dispenser drip tray is to be connected to a permanent drain, the drain access must be within 6 ft. of the machine. A 1- diameter hole is required for the drain tubing to pass through the counter. 3/8" I.D. tubing should be connected to the drip tray and run through the counter to the drain. If you require a hole in the countertop it must be done prior to installation. Installers will not cut or drill holes into your countertop. 'NOTE: All plumbing codes/requirements must be abided by when connecting permanently to a drain,