Laserfiche WebLink
Tank ID: <br /> 2. To determine lower tube distance from tank <br /> bottorn to bottom of cut: <br /> Subtract valve length(W)from distance to tank <br /> bottom(8) <br /> (V)=(B)-IW}_ <br /> Cast lug <br /> Not.: tower tube clearance must meet tank manu- in 715❑ <br /> factu rer requirements and a J I AKI,local,state,and na- body <br /> tional codes. Typical clearance is about 4". If lower Moat directiotx <br /> tube clearance Is not met valve must be removed and <br /> adjusted to meet these requirements. <br /> 3. To determine lower tube distance from tank <br /> bottom to top of cut. <br /> Subtract valve length(U)from dlstaneeto tank <br /> bottom(B) <br /> M=(6)-(ly)= <br /> Vkw Into drop tube front abovie <br /> Note. Lowe tube distance front tank bottom to top <br /> of cut must meet all AHJ,local,state,and national <br /> codes. For reference per 48 CFR 63 subpart CCCCCC{ <br /> N£SHAP the lower tube can be no more than G"from <br /> the bottom of the tank. If lower tube distance is not <br /> met valve must be removed and adjusted to meet these <br /> requirements. <br /> 4. To determine float alignment: <br /> Looking Inta upper tube(see figure)the float should be <br /> aligned along the length of the tank If float is not <br /> aligned properly adjustments need to be made. <br /> 21 <br />