COMPLIANCE INFO_2025 - Laserfiche WebLink

Home Browse Search

{{ PEIlkp1200-1 Z ATGs are programmed to monitor the product level in warnings or alarms. In the event of any storage tanks and can be programmed to perform com- such waWmgs or alarms, notify the appm- plianee tests that can include 0.2 gph static and dynamic priate person before continuing the test. (""continuous") leak teats.and 0.1 gph ("precision") tests. herG possible print out the system setup 8. .1 ATG Functionality Test. and any alarm historbes from the console. 8.2"1,1 General. The ATE must be pro- Save the printout for facility records or make an elecuan.ic copy. gr nuned using site-specific parameters far the LIST sysmrn to ensure proper opera- 8.2.1.5 'rest Equipment. Mast cquip- lion. On dual float systems, the second nient shall include: float indicates the level of water in the ■ tools for the removal of the ATG probe tank. and sensors; 8.2.1.2 Purpose. The purpose of this ■ tape rneasure or gauge stick; test is to: ■ water-finding paste. • tie#ermine whether the ATG shows She oorrmt product level on the console; 8. .1.8 Test Procedure. • determine whether the ATG shows the 1.Measure the product and water level correct water level on the console; in the tank and compare to the console verity that the water Warm is operating readings to confirm ATG accuracy. If correctly and provides a warning at the the readings do not agree, contact the progmmmed set point. appropriate person. 2.Remove the ATO probe cep and discon- WARNING: Water Ingress into tanks con- nect the cable from the ATG. taining ethanol-blended gasoline may not 9.Remove the ATG probe, frorn [he tank. be detected using water floats designed Use care to ensure that the floats on the toy non-ethanol-blended gasoline. stem do not catch on the bottom of the riser dudng removal, 8.2.1.3 Description of Test. The pro_ 4.Ynspect the probe.The floats must move cedures in this test are for a probt:,properly fly on the stern without binding, If installed per Manufacturer's instructions, any pawls are damaged or missing, con- equipped with floats having a range inside tact thr appropriate person. the tank that extends from the bottom to G.Recofinect the probe cable. the top of foe tank. 8. Set the furl float in the middle of the The ATO probe is removed from the tank. probe and verify that it is showing the The product float and water float positions correct inch reading on the console. are compared with the console readout. T.Slowly move the fuel float up tho probe 8.2.1.4 Prepamtlon. Use this Sect pro- until the high product alarm is triggered eedure in conjunction with the monitor- on tl�e console. If the system does not ing system manufacturer`s installation and alarm at the pre-set level, contact the maintenance instructions. appropriate person. Refer to the tank manufacturer's Sank B.Measure the distance from the bot- cbw for the capacity in gallons, the dram- tom of the probe to the fuel float wlicn etcr and the volume of product that corre- the float first triggers the high product sponds to the product level. alarm, Verify that the console has no active or 2.Clear the alarm conditions, recurring history of teak defection-related pei.org