Laserfiche WebLink
INSTRUCTIONS FOR SEALING B-2000 <br /> FLOAT CUP RESERVOIRS <br /> Approved materials: Bravo FRP Plug and Bravo Epoxy Kit <br /> 1) Remove all liquids, debris and contaminants from the interior of the B-2000 UDC. <br /> 2) Remove the float and float arm assembly so it is clear of the float cup area. <br /> 3) Abrade and clean up the float cup area. Remove mineral buildup, dirt and any other debris. If rust <br /> is present, be cautious to not cut yourself, or bend any metal inwards. Use a wire bristle brush to rough <br /> up and smooth out rusty areas if present. <br /> 4) Clean the top edge of the float cup where it intersects with the bottom floor of the B-2000 UDC. <br /> 5) Keep the float cup area dry. If water is present under the cup, or it is flowing up into the <br /> containment sump, inject a water barrier polyurethane foam or filler in order to stop the flow of liquid. <br /> 6) Ensure the float cup and interior of the sump is completely clean and absolutely dry prior to <br /> adhesive application. <br /> 7) Ensure that the exterior of the fiberglass float cup plug is clean of fingerprints, debris and <br /> contaminants. Clean with acetone to be certain and maintain a clean and dry state. <br /> 8) Apply mixed Bravo adhesive generously to the bottom and outside edges of the fiberglass float cup <br /> plug, applying a heavy amount around the lower half. Use chip brush to wet out the interior of the <br /> existing float cup area with adhesive as well. <br /> 9) Insert the plug into the float cup and press firmly, rotating it until the float cup bottoms out. You <br /> should have applied enough adhesive so that it oozes out. Press it as far down as you can until the <br /> top edge of the plug is flush with the bottom floor of the B-2000 UDC. <br /> 10) Using the chip brush, spread around or apply adhesive at the seam between the plug and the <br /> bottom floor of the B-2000 UDC where they intersect. <br /> 11) Allow a full cure of 8 hours at or above 70T. Do not allow the adhesive to come in contact with <br /> water or moisture while it is curing. <br /> 12) Water test the UDC per typical procedures. <br /> ii-B2000-PLUG-13A <br /> B�V� www.sBRavo.conn 105 made WBENC 1�P�/ <br /> PROBLEM SOLVED 800 AT BRAVO +� �� /`1 UJ lC•+r.n i, 't` ru j^'' MEMBER <br />