Laserfiche WebLink
Appendix A <br /> —71SOOver_fiILV_alveUpperTube_C_alculation_W-orksheet__—_ <br /> Important: This is meant to be supplemental worksheet and not a substitute to following the installation <br /> manual instructions. All length measurements are in inches. Please contact the Authority Having Jurisdic- <br /> tion(AHJ)and review local,state,and national codes to determine the regulatory requirements governing <br /> shut-off capacity in your region,as well as take into account other considerations such as extreme tank tilt. <br /> Desired tank capacity for shut-off: SO%= CU-•5 <br /> Dipstick Number(Y) on Tank Chart that corresponds to 100%volume (y) <br /> Dipstick Number on Tank Chart that corresponds to SO%(X)_ •g (X) <br /> Upper Tube Reference Number Z=Y-X ® (Z) <br /> Upper Tube Depth Inside Tank C=Z-2" 2 <br /> Distance from top sealing surface for 71 SO Lip'to inside the (C) <br /> top of Storage Tankz A= '{ <br /> For Non-Testable 71 SO models only <br /> In all cases for non-testable 71 SO models,the top of the valve body must protrude at least 61/2"into the tank to <br /> provide a minimal clearance for proper operation 3 Additionally the total Upper Tube Length must be at least 16" <br /> of length to include the protective bend in the tube. <br /> Is C less than 6.1/2" Yes / No <br /> If NO,Upper Tube Length(D)=C+A <br /> If YES,Upper Tube Length(D)=6'/2"+A <br /> Upper Tube Length= J <br /> For Testable 71 SO models only <br /> In all cases for Testable 71 SO models,the top of the valve body must protrude at least 6'/2"into the tank to provide <br /> a minimal clearance for proper operation.' Additionally the total Upper Tube Length must beat least 14'/z"of <br /> length to include the protective bend in the tube. <br /> Is C less than 6 1/2" Yes / No <br /> If NO,Upper Tube Length(D)=C+A-1 '/2" <br /> If YES,Upper Tube Length(D)=6'/2"+A- 1 '/2" <br /> Upper Tube Length= <br /> ' Sealing surface may be the top of the Face Seal Adaptor,the built in sealing ledge inside some spill containers,or on non-vapor <br /> tight applications the top of the pipe nipple <br /> 1 Some Underground Storage tanks utilize a man way system at the top. Make sure to use the top of the storage tank for measure- '... <br /> mentandnottotopofthemanway. Consultyour underground tank manufacturer for height of the manway <br /> 3 This measurement is taken from the seam where the upper tube is attached to the valve body to the inside of the tank top. <br /> 20 <br />