COMPLIANCE INFO_2025 - Laserfiche WebLink

Home Browse Search

Chevron Monitoring Certification Checklist Store Number: Address: 1222 W Atherton Manteca, CA 95337 Date: 8/18/2025 Technician: Carlos Zaragoza Company: TANKNOLOGY INC. Step Instruction T1 REGULAR T2 PREMIUM T3 DIESEL Yes (especially tank manifolding setup - see Note 2) Product REGULAR PREMIUM Biodiesel Yes Make a note if sensor label missing or illegible, & approx. cord length for -208/-209 with missing labels Tank Type Fiberglass Fiberglass Fiberglass (DW FRP, DW Steel, SW FRP) 1 Annular Riser Height (measured) 2 Tank Diameter: (from tank chart, 118.38 in. 118.38 in. 118.38 in. for example: 118.375",117.75",111';92",etc.) 3 For FRP tanks, 1/2 circumference of the tank 185.86 in. 185.86 in. 185.86 in. (0.5 X3.14 X tank diam.) OR (q.57 x step 2) Required annular sensor length: 4 FRP = Riser+ 1/2 Circumference = step 1 + step 3 185.86 in. 185.86 in. 185.86 in. Steel = Riser+ diameter = step 1 + step 2 Mark & label the required sensor length on 5 sensor cord. Label should be under the cap & Yes Yes Yes serve to prevent the cord being pulled too short. Is tank annular sensor in the correct position? Yes Yes Yes 6 FRPTanks: with the marked required length lining up with the top of the annular riser? Yes Yes Yes Steel Tanks: sensor touching bottom with slack above the marked required sensor length? Are the DW pipe boots pulled back in tank sumps? 8 (YIN or N/A, note if can't be verified because Yes Yes Yes clamshell pointing down) Are tank sump sensors back in their holders and 9 in the correct position? Yes Yes Yes (YIN or N/A document with photo) Approximate gallons of product dispensed for 7 purging, etc. and returned to tank Has the Veeder Root Battery been replaced & dated prior to failsafe? See Comment (if battery backup failed, label and leave failed battery on top of console, note in comments and advise your OM) Has Veeder Root Programming before & after testing been printed & verified? Yes (especially tank manifolding setup - see Note 2) Has Veeder Root Programming before & after been attached to the Work Order? Yes Have all sensor model numbers been verified against the Veeder Root cord label? Yes Make a note if sensor label missing or illegible, & approx. cord length for -208/-209 with missing labels Additional Comments: Site has 303 brine sensors for annulars. Note 1: Certain Veeder Root Software versions will automatically revert to the default tank manifold settings anytime the programming is changed, such as when sensors are temporarily Ved out, etc.