Laserfiche WebLink
Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements. <br />POWER COROPOWER CORD POWER CORD <br />120 volt ac models 230 volt ac models 208 & 240 volt ac models <br />>OWER CORD <br />DUAL VOLT TOGGLE SWITCH <br />46819 0430125 <br />L <br />whfhJ <br />Note: This electrical service consists <br />of 2 current carrying conductors (LI <br />and L2) and a separate conductor for <br />earth ground. <br />120/208 & 120/240V ac <br />single phase models <br />ELECTRICAL REQUIREMENTS <br />WARNING - The dispenser must be disconnected from the power source until specified in Initial Set-Up. <br />• <br />■ ®@ <br />■ <br />®® <br />NEUTRAL | <br />• ■ <br />___GRHWELLOW <br />| I? REPNHJIRAI WHiTt <br />Note: This electrical service con- Note: This electrical service con­ <br />sists of 2 current carrying conduc- sists of 2 current carrying conduc­ <br />tors (LI and Neutral) and a separate tors (LI and Neutral) and aseparate <br />conductor for earth ground. conductor for earth ground. <br />CE REQUIREMENTS <br />• This appliance must be installed in locations where it can be overseen <br />by trained personnel. <br />• For proper operation, this appliance must be installed where the tem­ <br />perature is between 5°C to 35°C. <br />• Appliance shall not be tilted more than 10° for safe operation. <br />• An electrician must provide electrical service as specified in conformance <br />with all local and national codes. <br />• This appliance must not be cleaned by water jet. <br />• This appliance is not intended for use by persons (including children) <br />with reduced physical, sensory or mental capabilities, or lack of experience <br />and knowledge, unless they have been given instructions concerning use <br />of this appliance by a person responsible for its safety. <br />• Children should be supervised to ensure they do not play with the ap­ <br />pliance. <br />• If the power cord is ever damaged, it must be replaced by the manufac­ <br />turer or authorized service personnel with a special cord available from <br />the manufacturer or its authorized service personnel in order to avoid a <br />hazard. <br />• Machine must not be immersed for cleaning. <br />Electrical Hook-Up <br />CAUTION - Improper electrical installation will damage electronic com­ <br />ponents. <br />1 .An electrician must provide electrical service as specified. <br />2. Using a voltmeter, check the voltage and color coding of each conductor <br />at the electrical source. <br />3. Turn off master switch (if equipped). <br />4. Remove the upper and lower rear panels. Note: This electrical service consists <br />5. Install the proper electrical wiring to the terminal block. of 3 current carrying conductors <br />6. Connect the dispenser to the power source and verify the voltage at (Neutral, L1 and L2) and a separate <br />the terminal block before proceeding. Reinstall both rear panels. conductor for earth ground. <br />7. If plumbing is to be hooked-up later be sure the dispenser is discon­ <br />nected from the power source. If Plumbing has been hooked-up, the <br />dispenser is ready for Initial Set-Up.