SU-2601466 - Laserfiche WebLink

Home Browse Search

(1) All required front and street-facing side setbacks, except for areas used for driveways and entries, shall be landscaped (Development Title Section 9-402.030(a)) (2) Protective six-inch concrete curbs or standard concrete wheel stops shall be required where planting abuts parking stalls, loading areas, driveways, or tum-around areas. (Development Title Section 9-402.0400)) c) SURFACING: The following requirements apply and shall be shown on the Site Plan: (1) All permanent parking lots, including internal circulation and loading areas, in all zones-shall be surfaced and permanently maintained with asphalt concrete or porfiand cement concrete to provide a durable, dust free surface. (Development Title Section 9-406.060(i)) (2) Ingress and egress areas that connect to a paved road-or highway shall also be surfaced and permanently maintained with asphalt concrete or Portland cement concrete or with pervious pavements,sand-set pavers,and supported turf systems.A combination of surfaces may be used; for example,two track driveways of concrete strips with pervious areas between the strips and on the edges. Bumper guards and/or wheel stops shall be-provided when necessary to protect adjacent structures or properties. (Development Title Section 9-406.060(i)) d) LIGHTING: Lighting shall be provided and comply with the following: (1) All off-street parking areas within Commercial and Industrial-zones and for projects where the parking area is used at night, shall be provided with exterior lighting that meets the following minimum standards: (A)-The equivalent of one foot candle of illumination shall be provided throughout the-parking area. (Development Title Section 9-406.060(m)(1)) (B) All lighting shall be on a time clock or photo-sensor system so as to-be turned off during daylight hours and during any hours when the parking area is not in use. This requirement does not apply to security lighting. (Development Title Section 9-406.060(m)(2)) (C) All lighting shall be designed to confine direct rays to the premises. No spillover beyond-the property line shall be permitted, except onto -public roads, provided, however, that such light shall not cause a hazard to motorists. (Development Title Section 9-406,060(m)(3)) e) ACCESS ANDCIRCULATION: The following requirements apply and shall be shown on the Site Plan: (1) Access driveways shall have a width of no less than 25 feet for two-way aisles and 16 feet for one- way aisles,except that in no case shall driveways designated as emergency access for fire districts be less than 20 feet wide. (Development Title Section 9406.060(n)(1)) f) BUILDING CODE REQUIREMENTS: The following California Building code (CBC) and San Joaquin County Ordinance requirements will be applicable to the proposed project. The following requirements shall be addressed prior to submittal of a building permit application to the Building Inspection Division: (1) Commercial Building Permit Submittal Requirements (A) Application Submittal Policy (i) Permit Scope:A Building Permit is required for all proposed new structures. (ii) Professional Credentials: All Plans must be prepared, signed, and stamped by a PA-2600269—Standards and Ordinance Requirements 2