Permits & Development - Encroachment(EP)/Driveway(DW) Permits - 2012_PS-1202001 thru PS-1202500_ - PS-12-02067

Home Browse Search

SPECIAL CONDITIONS FOR PG&E-WEST RIPON RD.-PM 30941357 ENCROACHMENT PERMIT 1. Maintain traffic controls for all roads. Traffic control delays shall not exceed 15 minutes. Two-way traffic shall be maintained during non-working hours with excavated areas backfilled or plated. During working hours, two-way traffic control shall be maintained with one lane open and appropriate flaggers. 2. No working within the actual roadway (travelled-way) between the hours of 6:00 a.m. to 9:00 a.m. and 3:00 p.m. to 6:00 p.m. Working within the shoulder of the right-of-way is allowed, as long as the traffic is not interfered with, during these hours. 3. Access to all properties shall be maintained at all times except when work is occurring at the access point. Minimal delays will be allowed to provide access within the work zone area. Driveway access shall be fully restored at the end of each workday. Driveways disturbed by the contractor shall be replaced with in-kind or better materials. 4. Residents and businesses shall be notified of the work schedule in writing, as approved by the County, 48-hours in advance of any impacts to their access. 5. Any areas where parking is to be restricted shall have signs noticing the time period placed at least 48 hours in advance of the work. 6. All pipe and pipeline related facilities including, but not limited to, valves, utility boxes and vaults, and frames and covers shall be maintained by Pacific Gas & Electric Company (PG&E). PG&E shall be responsible for any and all costs associated with the relocation and/or adjustment of these facilities as determined by the County at PG&E's expense. (Streets and Highways Code 1463) 7. All future maintenance of the pipeline and related facilities within the County right-of-way will require a San Joaquin County Encroachment Permit. 8. Length of open, unbackfilled trench shall be limited to a total maximum length of 250 linear feet during working hours. 9. Trenches shall be maintained in a smooth and even condition to the satisfaction of the County throughout the project limits at all times. 10. All trenches/bell holes shall be completely backfilled or shored and plated at the end of each workday, and the roadway restored to two-way traffic. If plating is to be used, a trench shoring and plating plan suitable for traffic loadings shall be prepared by a registered civil engineer and submitted for prior approval by the County. 11. The contractor shall use San Joaquin County Standard R-29 when backfilling trenches/bell holes within the County right-of-way. Where the existing road structural section is below standard, a minimum section of 3 inches of asphalt concrete over 8 inches of aggregate base shall be required.