Laserfiche WebLink
Special Conditions for -2- <br />ENCROACHMENT PERMIT <br />be disturbed shall be located and referenced by a Licensed Land Surveyor, and a Corner Record <br />filed with the County Surveyor. Any Survey Monuments disturbed during the course of <br />construction shall be reestablished by a Licensed Land Surveyor and another Corner Record filed <br />with the County Surveyor. (Land Surveyors' Act Section 8771) <br />15. All pipe and pipeline related facilities including, but not limited to, valves, utility boxes and vaults, <br />and frames and covers shall be maintained by City of Stockton, including any facilities that are <br />abandoned in place. City of Stockton shall be responsible for any and all costs associated with <br />the removal, relocation and/or adjustment of these facilities as determined by the County at City <br />of Stockton's expense. (Streets and Highways Code Section 1463) <br />16. All future maintenance of the pipeline and related facilities within the County right-of-way will <br />require a San Joaquin County Encroachment Permit. <br />17. Trenches/bell holes shall be maintained in a smooth and even condition to the satisfaction of the <br />County throughout the project limits at all times. <br />18. All trenches/bell holes shall be completely backfilled or shored and plated at the end of each <br />workday, and the roadway restored to two-way traffic. If plating is to be used, a trench shoring <br />and plating plan suitable for traffic loadings shall be prepared by a registered civil engineer and <br />submitted for prior approval by the County. <br />19. The contractor shall use San Joaquin County Improvement Standard R-29 when backfilling <br />trenches/bell holes within the County right-of-way. Where the existing road structural section is <br />below standard, a minimum section of 3 inches of asphalt concrete over 8 inches of aggregate <br />base shall be required. <br />20. Myran Avenue subject to pavement cuts shall receive a Type II Slurry Seal Coat as per San <br />Joaquin County Department of Public Works Improvement Standards Section 2-5.0 Trench Cut <br />Policy. Shoulder areas shall be brought up to the finish grade as directed by the County. <br />21. Final paving for trench repair or road resurfacing shall be per Caltrans' specifications and shall <br />not occur between November 1 and March 31, without prior authorization from the San Joaquin <br />County Department of Public Works Field Engineering Division, contact them at 209-953-7421. <br />22. No paving joints are allowed within paved shoulder; contractor shall pave all the way to outer <br />edge of paved shoulder. <br />23. Class II Aggregate Base shoulder backing is required from the edge of pavement, a minimum of <br />4 -inches thick by 4 -feet wide. <br />24. Contractor shall establish existing roadway and drainage grades within the construction area. <br />Any repair to roadways and adjacent areas shall match existing grades. Any proposed grade <br />changes shall receive prior approval from County. <br />