Laserfiche WebLink
Special Conditions for -2- <br />ENCROACHMENT PERMIT <br />the removal, relocation and/or adjustment of these facilities as determined by the County at <br />California Water's expense. (Streets and Highways Code Section 1463) <br />13. All future maintenance of the pipeline and related facilities within the County right-of-way will <br />require a San Joaquin County Encroachment Permit. <br />14. Trenches/bell holes shall be maintained in a smooth and even condition to the satisfaction of the <br />County throughout the project limits at all times. <br />15. All trenches/bell holes shall be completely backfilled or shored and plated at the end of each <br />workday, and the roadway restored to two-way traffic. If plating is to be used, a trench shoring <br />and plating plan suitable for traffic loadings shall be prepared by a registered civil engineer and <br />submitted for prior approval by the County. <br />16. The contractor shall use San Joaquin County Improvement Standard R-29 when backfilling <br />trenches/bell holes within the County right-of-way. Where the existing road structural section is <br />below standard, a minimum section of 3 inches of asphalt concrete over 8 inches of aggregate <br />base shall be required. <br />17. East Main Street subject to pavement cuts shall receive a one -inch (1 ") asphalt concrete overlay <br />as per San Joaquin County Department of Public Works Improvement Standards Section 2-5.0 <br />Trench Cut Policy. Shoulder areas shall be brought up to the finish grade as directed by the <br />County. <br />18. Anteros Ave., Drake Ave., and Hinkley Ave. subject to pavement cuts shall receive a Type II <br />Slurry Seal Coat as per San Joaquin County Department of Public Works Improvement <br />Standards Section 2-5.0 Trench Cut Policy. Shoulder areas shall be brought up to the finish <br />grade as directed by the County. <br />19. Final paving for trench repair or road resurfacing shall be per Caltrans' specifications and shall <br />not occur between November 1 and March 31, without prior authorization from the San Joaquin <br />County Department of Public Works Field Engineering Division, contact them at 209-953-7421. <br />20. No paving joints are allowed within paved shoulder; contractor shall pave all the way to outer <br />edge of paved shoulder. <br />21. Class II Aggregate Base shoulder backing is required from the edge of pavement, a minimum of <br />4 -inches thick by 4 -feet wide. <br />22. Contractor shall establish existing roadway and drainage grades within the construction area. <br />Any repair to roadways and adjacent areas shall match existing grades. Any proposed grade <br />changes shall receive prior approval from County. <br />23. Above ground vaults, panels and/or other similar facilities will be allowed within the right-of-way if <br />located as far to the outside edge as possible. Utility vaults shall be located a minimum of 4'-0" <br />from edge of pavement. <br />