Permits & Development - Encroachment(EP)/Driveway(DW) Permits - 2023_PS-2302501 thru PS-2303000_ - PS-2302966

Home Browse Search

Areas: The entire shoulder of the road is to be resurfaced. The existing surfacing adjacent to the trenched area shall be planed to accommodate the overlay in a manner that does not cause drainage concerns. The nearest pavement cut shall be a minimum of three (3) feet from the edge of pavement, or the remaining pavement shall also be removed and replaced. (See County Standard Drawing No. R-37). 2. Longitudinal Trenches within Traveled Lanes: The entire traveled lane where the trench is located is to be resurfaced with a one (1) inch asphalt concrete overlay. The existing surfacing adjacent to the trenched area shall be planed to accommodate the overlay in a manner that does not cause drainage concerns. The overlay shall be in accordance with State Standard Specifications, Section 39. Aggregate gradation shall be consistent with the existing surfacing material. (See County Standard Drawing No. R-37). 3. Cross -Cutting: Cross -cutting is allowed at a minimum interval of 150 feet. At each cross -cut location a minimum of ten (10) feet on each side of trench shall be planed and resurfaced with one (1) inch asphalt concrete. If cross cuts are within the 150 feet minimum interval, the entire section between the first and last cross cut shall be planed and resurfaced with one (1) inch asphalt concrete. (See County Standard Drawing No. R-36). 4. The conditions described in paragraphs 1, 2 and 3 above will not apply if resurfacing is scheduled within two years. 2-5.03 Local Roads A. Surfacing Age Under Three (3) years: No pavement cuts allowed. Exceptions may be approved in accordance with Section :2-5.04 EXCEPTIONS. B. Surfacing Age Three (3) to Five (5) Years: Longitudinal cuts are permitted. A seal coat is required for that half of the roadway containing the trench. (See County Standard Drawing No. R-37). 42