Laserfiche WebLink
California MUTCD 2014 Edition <br />(FHWA's MUTCD 2009 Edition,including Revisions 1 &2,as ameuded for use in California) <br />Notes for Figure 8M HI6H-lO(CA)and 6H-l OA(CA)-Typical Application 10 <br />Lane Closure on a Two-Lane Road Using Flaggers <br />Page 1157 <br />Option: <br />1.For low-volume (Refer to Pari 5,Section 5A.O!)situations with short work zones on straight roadways <br />where the flagger is visible to road users approaching from boih directions,a single flagger,positioned to be <br />visible to road users approaching from both directions,may be used (see Chapter 6E). <br />2.The ROAD WORK AHEAD and the END ROAD WORK signs may be omitted for short-duration <br />operations . <br />.3.Flashing waming lights and/or flags may be used to call attention to the advance waming signs. <br />A BE PREPARED TO STOP sign may be added to the sign series. <br />Guidance:4.The buffer space should be extended so that the two-way trafflc taper is placed before a horizontal (or crest <br />vertical)curve toprovide adequate sight distance for the /Jagger and a queue of stopped vehicles. <br />Standard: <br />5.At night,flagger stations shall be illuminated,except iu emergencies. <br />Guidance: <br />6.When used,the BE PREPARED TO STOP sign should be located eetweeB arterthe Flagger sign and the I <br />ONE LANE ROAD sign.7.When a grade crossing exists within or upstream of the transition area and it is anticipated that queues <br />resulting from the lane closure might extend through the grade crossing the TTC zone should be extended <br />so that the transition area precedes the grade crossmg8.When a grade crossing equipped with active warning devices exists within the activity area,provisions <br />should be made for keeping /Jaggers informed as to the activation status of these warning devices.9.When a grade crossing exists within the activity area,drivers operating on the left-hand side ofthe normal <br />center line should be provided with comparable warning devices as for drivers operating on the right-hand <br />side of the normal center line. <br />10.Early coordination with the railroad company or light rail transit agency should occur before work starts. <br />Option: <br />11.A flagger or a uniformed law enforcement officer may be used at the grade crossing to minimize the <br />probability that vehicles are stopped within 15 feet of the grade crossing,measured from both sides of the <br />outside rails. <br />Support: <br />12.For State highways,see Caltrans'Standard Plan T13.See Section 1A.11 for information regarding this publication. <br />13.If portable transverse rumble strips are used for flagging operations,refer to Section 6F.87. <br />Chapter 6H -Typical Applications <br />Part 6 -Temporary Traffic Control <br />November 7,2014